HI I HAVE A PRO TALK KENWOOD TK2400 I FOLLOWED THE RESET INSTRUCTIONS BUT THE ORNAGE LIGHT WONT TURN ON SO IT IS NOT LETTING ME RESET

Try this and please let me know it it works for you. A pro mechanic told me a week ago that I am talking rubbish, but I got this FROM a pro mechanic and it has worked for many members here.
Resetting a Vehicle Anti-Theft System after Battery Disconnect
This is how you reset an anti theft system if you have the anti-theft light on, or your car is cranking, but you have no spark.

Doing a full reset of the anti-theft system.

Disconnect both battery leads for at least two hours.
Hold the negative and positive leads together for 5 minutes to fully discharge any residual power in capacitors.
Put the key in the ignition, but not turned on or Fob close to steering wheel. VERY IMPORTANT!
Connect the positive lead.
Connect the negative lead in one swift movement.
Wait 15 minutes for the system to fully reset.

Krx-89 stand by light wont turn off - Fixya

www.fixya.com/support/t14712608-krx_89_stand_light_wont_turn_off

Oct 20, 2012 - krx-89 stand by light wont turn off Stero doenst play is it because thestand by light is on? How do i turn off - Kenwood Audio & Video Receivers ...

How do you turn off standby on a kenwood krx-89 stereo ...

www.fixya.com/.../t15447523-turn_off_standby_kenwood_krx_89_ster...

Dec 20, 2012 - Hi, is the red light that says power On? If not, it could just be the fuse since I had the same problem. If you take the lid off, it should be in the left ...

Read - Document Download

Be sure the "Channel" and "Code" settings are the same on all radios.

In the first instance you need to check your power lead. Exchange it for another one that you know works.

The Instruction Manual for the Kenwood FP730 Multipro Food Processor can be found online here:

http://www.kenwoodworld.com/Global/Instruction%20books%20(User%20manuals)/Food_Processors/57832%20Iss%203%20B5%20FP730%20English%20only.pdf

Hi,

You could Download the manual from :-

http://safemanuals.com/user-guide-instructions-owner-manual/KENWOOD/FP486--2405%20FP480%20%2526FP580%20ENG

You need to have Acrobat Reader to View this.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Hi,

This is an indication that the water did not heat properly, I have put together instructions on how to reset the control so you can use the dishwasher and things to check to resolve it from coming back. Follow the link and let me know if it helps.

http://www.fixya.com/support/r4628906-flashing_or_blinking_green_clean_light_7

Please put back lamp cover, the last plastic grille that were removed to replace lamp in TV.
TV sense that lamp cover is not either put back or not fixed properly so it wont turn On. Check lamp cover and problem will be solved.
Thanks.

broken wire on the mike line or bad mike element.

Hi John Steel

Try disconnecting it from all 12 volt sources(overnight)to reset the code entry procedure. If that dont sort it, let me know and we shall try something else

regards
robotek