Hi. Have a smeg range cooker. Due to recent power cut oven won't reset. Which buttons do we need to hold down to reset. Thank you.

Check if the oven timer is on auto mode. If it is, turn it on to manual mode .
Remove the power cable from the outlet and wait for 20 minutes. As you plug your oven back in, the oven timer should reset as well .
Hold the timer buttons down at the same time to reset the timer .
Meter the thermostat out and see if it's open circuit .
Take the top off and inspect the selector switch and see if there are any signs of burning on the switch .
How to Repair ' Smeg duel fuel range cooker A1-7 Oven not working. (how-to-repair.com)

remove cast iron pot stands and pull off all knobs and small timer buttons. lower the oven doors and look up under the panel holding the knobs and you'll see a screw at each end, remove them. you can now remove the stainless switch panel, (swing the bottom out first) you can now get access to screws at each top corner which should be removed. you can now lift the top panel of the cooker by about 5 inches when a pivoted stay should drop down each side to allow you to rest the top in an open position.

Hello,
Unfortunately, I don't have a solution for you. That's because I have exactly the same problem. Did you ever discover how to fix this problem?

whilst alarm is ringing press the minus (-) button. there are 3 volumes to choose.

buy a pack of 2 oven shelf guards from lakeland 10.99. cut them in half and slide onto the ends of the 2 shelves. works perfectly.

instalation wiring may be criss crossed if under warranty get them out to fix it.

my smeg oven has always never worked properly, the temperature is faulty etc i now want to remove this oven and have bought a new electrical oven but cannot seem to get the smeg oven out. How do i remove this smeg oven?

the fan element would have blown. it is not uncommon for an element to trip an rcd when it blows. you are on the right track, if you replace the element all your problems should go away

sound like the TOD to me. have a technician replace it.

This problem is caused by one of two components, depending on the model, there is a thermal cut in thermostat that keeps the fan running until the unit has cooled down and on some models there is a four wire timing device that keeps the fan running for a specific time after the temperature drops, the fault can only be casued by one of these components. Smeg Service Engineer