Jabra BT 5020 Headset, previously unopened, shows no indication of charging or turning on, what is the issue/how do I fix this?

Did it used the charge before?
How long do you have it for?
How often is it required that you change your battery?
Is your charger really connected to the power socket?
Does it show a charging light?

Hi,

Follow the instructions mentioned below to resolve the issue:

• Charge the headset
• Charge your Jabra VBT185Z until the solid LED turns off
• (approximately 2 hours)
• Turning the headset On and Off
• Press the answer/end button until you see a burst of flashes on the
• indicator light (LED) to turn your headset on or off.

Headset Pairing Readiness Instructions:

1. Fully charge headset for two hours.
2. The headset will automatically go into pairing mode if no device has
been previously paired.
3. Set your mobile phone to 'discover Jabra VBT185Z'.
4. Enter passkey or PIN = 0000 (4 zeros), then press Yes or OK.

For online pairing assistance visit www.verizonwireless.com/bluetooth.

Hope the above steps allows you to resolve the issue. Please revert back for any further clarification.

Regards

Anand

hello,buy travel charger BT200/BT250/BT250V and you will have your bluetooth headset charging back.

Take care.

I called Jabra Support and they are sending out another unit. The technician indicated that the battery is likely defective and is not field replaceable.

Thank you,

I have the env Touch and the Jabra Halo. Initially, I had a problem pairing the two, then I realized that I was not following the directions properly. The manual shows two sections for pairing ("first time pairing" and "later pairing"). I was following the instructions for the former when I should have been following the latter. I also failed to notice that the BT indicator was flashing blue and not solid blue, as it needs to be, for pairing mode. So, if you haven't already done so, follow the instructions for "later pairing" here. Make sure that you see the SOLID blue light on the BT indicator on the headset when you try to pair.

Have you tired to pair your hub with any other non-Jabra headset? I am trying with Plantronics Voyager 520 without success ;(

This is what I did:
1. open the headset by following these steps:
http://www.instructables.com/id/Jabra-BT-350-Disassembly-and-Repair/
2. measure the voltage of the battery. If it is too low, the internal charger circuit may not like it. Mine was 2.6v.
3. Charge the battery "manually" by connecting to 3 serially connected rechargeable batteries (final voltage should be around 3.7v). Three NiMH AA batteries are fine.
4. Reassemble and hope your headset is back to business.

If you hold down the button, it will turn the light blue, keep holding it till you can connect it. It will come up as Jabra BT125, hit connect. Then it will ask for a password. The password is 0000. Then it will connect :)

Try this link to help you on this site it is a battery problem

http://www.fixya.com/support/t190081-jabra_bt250v_indicator_light_doesnt