Need a 2 wire start diagram for generac 14kw off grid application

so repair it before you get injured -dont use it till repair done

Contact Generac directly to request the diagram.

Mount the transformer on the generator. Hard wire it into a 120 vac plug. Run wires to the module and connect to the coil on the relay. Now run the load you want to disconnect while the generator is running to the load terminals of the relay in the module.

take the old filter along to the spares shop and see if they can match it up
I suspect that the same filter will fit both engines
if you want to get technical, use a verniers to measure the thread hole diameter, a thread gauge to get the thread pitch, and the outside diameter of the oil seal
by going to oil filters manufacturers on line and researching their catalogues you will find pages of filters with dimensions that will match you filter
I would rather just go and buy a genuine filter from a mower shop or kohler dealer as there may be a generic filter already listed.

Please provide the serial number of the unit and what diagram you are looking for as there are many. I will email you the diagram

Assuming the generator circuit breaker is on, depending on the model it could be the voltage regulator or the slip ring brushes or both. If it's a portable it could be a capacitor problem.

si tiene transfer automatico solo poner un swicht en hilo 1N para cortar senal de entrada al generador del utility power que sensa la presencia de voltage en caso de falta arranca el generador en forma de prueba

here is a wiring diagram for that engine: