Which battery I must remove on e02 error in osp-37s5ar hitachi air compressor?

if you replaced capacitor exactly like it was remove and no wires switched you have a bad motor.

canon leserjet lbp 3150 error de service e100 0000

Depends on the make and model but an Error code E02 on most washing machines is slow water flow probably caused by a blocked filter! Remove panel on front bottom left or right side and clean filter! Should then clear error itself!

Nurit OSP Loader is the the program we use to remove the TAMPER error. Replacing the internal battery and reloading a fresh NOS (nurit operating system) will remove the error. Check our website at freshpoint.org or call us if you can at (775)358-2922 . It can be fixed, you don't need to replace it. thank you.hope this help : - )

do you have available Nurit 8020 terminals currently?are you purchase any tool for this? if no i have tamper recovery tool for this device.

To make it useable we need to remove the tamper first. Nurit OSP Loader is the the program we use to remove the TAMPER error. Replacing the internal battery and reloading a fresh NOS (nurit operating system) will remove the error. Check our website at freshpoint.org or cal us if you can at (775)358-2922 . It can be fixed, you don't need to replace it. thank you.
hope this help : - )

what type of air compressor you have,since when you maintained it

There should be a pressure switch adjustment under the cover of the switch remove the cover and reset.

Read what Juan Carrera wrote about this problem.

http://bellsouthpwp2.net/j/u/juancarrera/JVC/JVC%20Camcorder%20Errors.htm

E02 indicates that the mode switch did not rotate into the next position after 6 seconds during unloading attempt. This problem can occur for several different reasons, but almost always requires mechanism repair and retiming, a real pro job. Good luck, magic seadog