Squeaking while running when set to a low incline.

Two likely candidates: Belt or tread. Lubricating the tread would be the easiest starting point; but if you're running at 7 or more you've probably already thought of that.
If the cover isn't too difficult to remove, you can expose the drive belt and the squeaking volume change would be an indicator that the drive belt is the problem.

Talk to the manufacturer or take it back. It should not do this if it is brand new.

I would say it have to be bad joints or breaks.

Steering is all electronics these days so it can only be loosen.

time to get a new tread mill, ether that or get a lighter mouse to run on it.

It is probably your wheel bearings. Although, it is possible that your CV Axle could be damaged.

HI,

Its time to lubricate your treadmill.
You must obtain the proper lubricant for your treadmill. There are several different types. Contact your manufacturer for what type is needed. Using the manufacturer provided allen wrench, loosen the walking belt approximately 10 full turns on each side of the rear roller. Apply approximately 1/2 ounce of lubricant directly in the middle of the walk area underneath the walking belt upon the deck. Retighten the rear roller 10 turns on each side. Run the treadmill at 6.0 mph for 2-3 minutes to spread the lubricant evenly. Wipe excess lube from the sides of the belt. Walk on treadmill to check for proper tension on belt.
for make it easy for you I have added a video. ok

my amana nde5800ay electric dryer is making a loud squeaking noise

Usually when a treadmill begins to make a squeaking sound from the tread it means that the belt needs lubrication. Try Treadmill Belt Lubricant available at Canadian Tire for $10,99.

When microwave is running, turntable squeaking when rotating. Can problem be fixed? Microwave is about twelve years old.

There are four suspension rods that the tub hangs on. When the washer is agitating the tub will rock back and forth and the rods will move back and froth as well. To fix this noise, lift up in each rod and put some lubricant in the cup that the rods fit into at the top of the washer.

Note that it is best if you use a lithium-based lubricant rather than silicone based lubricant.

For more on do-it-yourself appliance repair help visit http://www.appliance-repair-it.com/index.html