How do I change the belt on an Eletrolux Nimble? I have taken off the top and still can't find the belt

How do i replace the power cord on electrolux nimble - Fixya

www.fixya.com/.../t25091002-replace_power_cord_electrolux_nimble

Sep 11, 2014 - Power cord is frayed next to body, need to replace it. how do i get ....See all Electrolux EL8602A Nimble Upright Bagless Vacuum Questions.

Amazon.com: Customer Reviews: Electrolux Nimble Upright ...

www.amazon.com/...EL8602A/.../B004GUFWBM

Amazon.com, Inc.Electrolux Nimble Upright Bagless Vacuum, EL8602A ... The rotating brush on/off buttons are located right under the soft-touch power button high up at .... Cord is a $30replacement part, which I'm regretting not doing from the get-go, due to ...

This is very easy, all you need to do is remove two quarter turn locks on the bottom plate and then you remove the plate and can assess the Electrolux Nimble Brush Roller 16136 1

Look to see if the belt broke or belt slip off most of the time is something wrong with the belt. If you change the belt of fix the belt that is the time you clean the brush.

it can be belt or clutch failed. put the vac on its side and on the bottom there will be either two push clips or 2 screws remove them or push them and pull the bottom off. then when this is off you will see were the belt is for the spinning brush. if the belt is still on then the clutch has gone in the motor if the belt has gone take out the broken part and get a new belt, fitting new belt you need to remove the spinning brush it is either clipped in or slotted in , clipped is push the clips out to the side and lift the brush out, slotted it will just pull out. clean out the brush before putting back in also check the brushes bearing to make sure it moves easy as a failed bearing do to carpet string etc can burn the belt, any belt that has been burnt in this way should be removed and changed as it will damage the hover if still used after this part has been cleaned replace all parts and then turn on dont and it pluged in mains while you are doing this and dont use until it has all been fitted back..

There are two Philip screws located on the edges of the back. Remove them this will allow the back to be taken off. Then remove the two screws at the top bracket that holds the filter in place..Ypu can remove the filter and bracket No need to remove any more of the screws on the back . From there you will see the plates and another filter. You can get at them by removing the two screws on the left and right of the plates..You can take the plates and filter out for cleaning and change the bulb if needed....NOTE; the filter on the back is resting on a activation switch just make sure when replacing the filter and bracket is pushed down to activate or the machine will not work..good luck....

Manuals

Hello!
The belt on your Magnesium is a fiber reenforsed belt that is designed to not stretch from normal use. Therefore it is not the easiest to acesss when it does need replaced. The belt will need replaced likely. The beltis on the left side of the vacuum and requires you to remove the side of the unit as well as to make it easier the bottom blue piece that is over the brushroller. Honestly I would advise anyone with this issue to take it to an Oreck repair center. Because ethe belts don't stretch it's difficult to roll the new belt on. Hope this helps!

Try to blow it out with some air

A common problem with roller/beaters is hair caught in the bearings on the ends of the roller. The roller is removable and requires regular cleaning or the belt will be destroyed.