Electrolux Air Purifiers - Recent Questions, Troubleshooting & Support


Refer this issue directly to Electrolux for guidance in replacing the handele.

Electrolux... | Answered on Mar 08, 2018


Sorry we do not have parts here or parts books,.

Electrolux... | Answered on Jul 06, 2017


How do i replace the power cord on electrolux nimble - Fixya

www.fixya.com/.../t25091002-replace_power_cord_electrolux_nimble
Sep 11, 2014 - Power cord is frayed next to body, need to replace it. how do i get ....See all Electrolux EL8602A Nimble Upright Bagless Vacuum Questions.

Amazon.com: Customer Reviews: Electrolux Nimble Upright ...

www.amazon.com/...EL8602A/.../B004GUFWBM

Amazon.com, Inc.Electrolux Nimble Upright Bagless Vacuum, EL8602A ... The rotating brush on/off buttons are located right under the soft-touch power button high up at .... Cord is a $30replacement part, which I'm regretting not doing from the get-go, due to ...

Electrolux... | Answered on Oct 02, 2016

Tip

Oven stopped working after self clean


Electrolux Double Oven EI30EW45JS1

After a self clean cycle the top oven stopped heating up. The keypad was operational, but there were no error codes. I determined this was due to the thermal switch being tripped. Unfortunately the oven has to be removed from the wall to get to the back where the switch is located.
Here is what I did:
1) Remove any trim around the oven in prep for sliding it out (see installation instructions).
2) Slide it out with a friend, on to a hydraulic table cart (1 used a 500 lb capacity one)
3) unplug the oven and remove the back panel.
4) Either reset the thermal switch by pressing the red button, or replace it. I found mine located on the upper left (facing it from the front)
5) replace the back panel
6) plug the oven back in
7) slide it back in place
8) replace the trim
The hardest part is getting the oven out, so I just replaced the switch and everything worked fine.

on Apr 30, 2016 | Electrolux EI30EW45JS | 30" Double...


I appreciate your post, friend!

From the information you have provided your Electrolux dryer's displays blinks on and off when you turn the dial and it does not start. This sounds like a possible issue with your door latch or control panel. I would recommend for you to check the door strike and door latch to make sure there is no visible damage. If you do not see any damage this could be a wiring issue within your door latch or control panel. This is not a simple DIY job and I would suggest having a professional out to perform an accurate diagnosis. I hope this is helpful information. -Matt

Electrolux... | Answered on Mar 05, 2015

Not finding what you are looking for?
Electrolux Logo

74 questions posted

Ask a Question

Usually answered in minutes!

Top Electrolux Air Purifiers Experts

ray gallant
ray gallant

Level 3 Expert

64299 Answers

Tom Chichester

Level 3 Expert

54195 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Are you an Electrolux Air Purifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...