What is the F20 code on the whirlpool duet front load washer?

Display shows F20 or FH - Front-load washer ' Whirlpool ...

https://www.whirlpool.com/...fh-front-load-...

Whirlpool Home AppliancesQuestion: Display shows F20 or FH - Front-load washer. Answer. Image. or. Image. or. Image. This error code indicates a water supply problem. Are both the hot ...

whirlpool duet error code FH - Appliance Repair Forum

forum.appliancepartspros.com > Appliance Repair Help > Washer Repair

Jan 5, 2009 - 10 posts - ‎1 author
... Repair Help > Washer Repair » whirlpool duet error code FH .... FH No water detected entering machine or Pressure switch trip not detected. Whirlpool Duet diagnostic code C:03 error code FH
1 post
Dec 5, 2014
Whirlpool Duet Washer HF Error Code
3 posts
Jun 10, 2013
FH Error Code on Whirlpool Duet Washer
2 posts
Mar 11, 2013
FH error code
9 posts
Sep 13, 2008
More results from forum.appliancepartspros.com

Stumped on error code FH for Whirlpool Duet front load washer .

Hi

Please check this link to get error F 20 resolved:-

http://www.appliancerepairlesson.com/2011/03/12/how-to-fix-whirlpool-duet-sport-error-code-f20-washer-repair-troubleshooting/

Please get back to us if you have further query else please accept the suggestion.
Thank you for contacting fixya.com

"F20" on display
(Water Inlet Problem-no water or insufficient
water supply) Select PAUSE/CANCEL twice to cancel the cycle
Unplug washer or disconnect power. Check the following: Are water faucets completely turned on?
Are screens at inlet hose connection to washer
clogged? Are water inlet hoses kinked?Are water inlet hoses frozen? also, those flood prevention hoses they sell you don't work well with front load washers

F20 No water detected entering machine, Defective flow meter, clogged water valve inlet screens.


Duet sport service manual

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

The F20 code for insufficient water going into the machine. Checked the hoses and water valves at the wall to make sure high pressure water is going to the washer.
You can try a different Cycle water temp setting. Like Cold/Cold or Hot/Hot to see which valve is not letting in the water.

There has been some know failures of the cold water inlet valves. That Whirlpool part number 8540751.
I hope this information has been helpful.
Good Luck.

A possible solution to an f 20 fill error for a whirlpool duet washing machine. Blow out the pressure hose that connects to the pressure switch.

After a time the small hose that comes from the pump area to the pressure switch located at the top of the machine can clog.
Unplug the machine.
Remove the top or the back of the washer.
Locate the pressure switch near the top of the washer. It is about 4 in round and has wires and a 1/4 inch black tube attached to it.Pull the tube from the switch and blow through the tube until clear.

make sure pump is clear. open toe panel and access pump.

I believe F20 may point towards a control unit failure.
You could try disconnecting it from the mains supply for a minute and plug it back in.
Hope this helps

That code means "No water or Insufficient water supply" Check the water supply valve, the fill hose screen for debris... Good luck let me know if that solved it..

does it do this a lot dont rate me till were done give me your complete model number