<!-- from fixya rte -->Nortel t7613e can't ring again - Nortel Networks Business Series Terminal T7316E

If they are wired, ensure you are using the correct sockets with the bell wire connected.

Feature **CONFIG,
Teeminals&Sets,
enter set #,
Telco Features,
1stDisplay,
use Change softkey to cycle between Number, Line, Name
Rls to exit programming.

You need a CI line card in the KSU.

In system programming, you can select whether the display is the name, number, or line.

F**CONFIG
Terminals&Sets
enter extension #
skip Line Access, Capabilities, Name, User Preferences
Telco Features
skip Feature Assign
at 1StDisplay use CHANGE softkey to toggle to NAME.

This is tech side programming known as Configuration, clients usually call in a tech/vendor for this.
You need to find out the password and know how to navigate the system programming, do F**266344 and enter the password.
Navigate to Sets, add line in question , assign ring type.

Hi,

i got this from Nortel expert and it works:

- press feature **266344
- user ID: 738662 Press ok
- Password: 266344 Press ok
Terminal & Extensions will appear
- press Call Timer button 1 time
write your extension or the extension you need to configure
or press find till you find the extension you need
- press Call Timer button 1 time
- press Ring Again button 4 times
Restrictions will appear on the screen
- press Call Timer button 1 time
Restrn Filter will appear
- press Ring Again button 1 times
- press Call Timer button 1 time
Filters will appear
- press Call Timer button 1 time
Normal 02 will appear ( it can be any 2 numbers)
- press CHANGE which appears on the screen
Type 00
and then press the end call button

You need to have a technician program your set to ring on incoming calls.

For paging u can't change the volume. The only way is to reduce ur phone's speaker volume.
Thanks.

You could have a CICS, and MICS or a Nortel BCM. Which do you have?

You will need to access admin programming, do you know how?

Make sure DRT is turned off/ set to no and on lines supervised is selected.

it may be turned down to low.press the program key and use the scroll bar below the keypad to find your option...hopes this helps