I have a Traxxas Revo 3.3 with reverse and when I turn it on it only goes reverse..... I try to shift and sometimes when I move the shift button on the remote the part on the truck that shifts the transmission doesnt move an the truck is still stuck on reverse. But when the part on the truck does move its still on reverse. Someone please help..... : ) : )
You might need to reset the opti drive. turn the power on with the engine still off and hold down the optidrive button for 5 sec. see it that works.
I can't seem to start the engine... I tried pretty much everything but nothing seems to work. When I use the EZ-Start, the engine keeps spinning but will not turn over. Any suggestions? I have ruled out everything in the manual and the truck has only ten runs on it. Obviously, I don't think I require a new engine. The last time I ran the model, it ran perfectly. Please help.
that happened to me one, would drain a fully charged ez start battery trying to turn the engine over, in my case, i had to flip the bearing that connects the ez start to the engine crank rod, it only spins loosley in one direction, so when in propper place, it should grab when ez start is ingaged and once engine is on it should spin freeley....hope this made since to you, explained it as best i could......good luck
×
2,389 views
Usually answered in minutes!
Thanks 4 the advice man but there was a problem with my tranny.
×