SOURCE: Misfeeds
DEAR SIR WHERE YOU REMPVE THE PAPER IN THE MACHINE THAT SECTION THERE IS PAPER PATH SENSOR ,THAT SENSOR POSITION IS ABNORMAL PLEAZ CHECK THE SENSOR OF THAT SECTION WHERE YOU REMOVED THE PAPER
SOURCE: misfeed trouble with sharp ar-337
Dear sir;I suggest you go to simulation mode 30 & 40 to find out which sensor got problem procedure as follow;
1, press "program", "interupt" "clear", "interupt"
2, enter 30, press "start", enter 01, pres start again,then all the sensor light in the paper path are on the abnormal one blinking.
3, repeat same step for 30 sub 02 that's for paper path in the feed section.
4, repeat same step for simulation 40 sub code 01,that's for by-pass paper path sensor.
After you done those procedure you will find out which sensor block out or defect, good luck.
HAVE A HAPPY HOLIDAY !!!
SOURCE: AR-M257 service code L1-00
L1-00 is determined as "scanner feed trouble". The scanner unit (which holds the mirrors) is not moving as it should be. There are a few possibilities. Firstly, does the mirror unit move when the copier is turned on? if not it could be a disconnected/broken scanner wire or bad drive motor or simply dirt/debris or a loose wire binding the unit up.
If the unit moves on power up then it could be a bad sensor or a bad board not registering the signal from the sensor.
You can check the operation of these items in SIM mode : press the following keys one after the other "P" "*" "C" "*" then press 1 and enter/copy button and you'll see the option available.
I hope that helps.
SOURCE: How do I get to the black toner reading on a Sharp AR-M257 copier
Hold down the Copy button and you should see a readout for the total copies printed from the copier and the percentage of toner left in the unit.
65 views
Usually answered in minutes!
×