Power acoustik plasma sphere - Power Acoustik TS1920-2 2 Channel 1920W Plasma Sphere Power Amplifier Car Audio Amplifier

you will get from
Sonic Electronix 28340 Avenue Crocker
Suite #202
Valencia, CA 91355

Generally, if you are using the manufactures fuse rating you can use a slightly higher rating and it will resolve the blowing fuses. Fuses supply resistance, if there isn't enough resistance you'll fry the system board in the amplifier. But if you have 25 amp fuses installed, install 30 amp, if you have 30 install 35 amp, 35 install 40. Anything higher will damage the amp.

Hope this helps.

A rare chance, something may be internally wrong with the amp and shorting it out which will blow the fuse.

Use the incorrect wiring of subs to the amp, you'll blow fuses and damage the amp from it turning off consistently. The amp should be running at 2 ohm stereo stable or 4 ohm mono stable.

Very few amps are designed to run at 1 ohm or less. Not to mention the subs can't handle it.

brake sphere for the ABS brakes its a nitrogen filled ballon inside a metal sphere ,just like citreon club or a rolls royce with hydraulic power brakes ,but its charged by a pump on your car via the computer

NEW POWER ACOUSTIK MOFO-122X 12" 2700W SUBWOOFER SUB

Check your ground and power wire.

one is peak power the other is the more accurate RMS power.

Hello adrieltoyota,

Here is the link to Power Acoustik's contact page. I'd recommend contacting them directly.

Hope this helps.

yes

If the amp goes into protect mode, it's likely due to shorted output transistors. To eliminate other possible problems, read through the following page:

Amp in Protect Mode - Troubleshooting

If the problems are not with the wiring, follow the link at the bottom of the page to the Amplifier Repair Primer page.

Let me know if you have any other questions.

look fix of conection line blak of cabel ithes+