Water damage display not working,

Error code E3 on a Hobart LXiH sanitizer/dishwasher typically indicates a problem with the water fill system. Here are a few things you can check to troubleshoot and resolve this issue:

1. Water supply: Make sure that the water supply to the dishwasher is turned on and that there is adequate water pressure. Check for any kinks or blockages in the water supply line.
2. Water inlet valve: The water inlet valve controls the flow of water into the dishwasher. Check to see if the valve is open and that there is no debris blocking the inlet. If the valve is faulty, it will need to be replaced.
3. Water level sensor: The water level sensor is responsible for detecting the water level in the dishwasher. If the sensor is not working properly, it can cause the dishwasher to display an E3 error code. Check the sensor for any signs of damage or debris.
4. Water pump: The water pump is responsible for pumping water into the dishwasher. If the pump is not working properly, it can cause the dishwasher to display an E3 error code. Check the pump for any signs of damage or debris.
5. Control board: The control board manages all the electrical functions of the dishwasher. If the control board is faulty, it can cause the dishwasher to display an E3 error code. In this case, the control board will need to be replaced.

You have 2 choices here. Attempt to dry it out by leaving in a dry warm place, or by an de-humidifier or by carefully taking the back off and letting it vent, or buy a new one. Not much else to do with that as the water is still in the device and not completely dried. Even after drying, it may not work, but it's worth a try before spending on a new one.

If your keypad lights and display is not working, then you have to service it. The display might got have damaged if it fells down or if some water spilled on that.. Make sure you keep your electronics free from water.

Thanks

sir , if it has water damage, its display will stop working. please rate my answer too

Hi, sorry about the water problem with your phone, Since you said the phone is already coming on but the display is still dark, What makes the display still dark is because the water it fell into has damaged an IC inside the phone,The IC makes the phone display.

So when you replace the phone IC that got damaged,the phone will display again,.

It was caused by water.
Take care.

No. Replace phone. The manufacturer won't fix water damage.

hi,
there are two kinds of white screen in n72 ,the first one is because of damage LCD (glass screen) ,defective display driver (small chips that makes the display works) and the other one is corrupted software...in damage lcd the phone will detected by computer because its software is still working...because your phone have an history of water damage ,maybe your display driver is damage...it needs to replace ,but before doing that ,try to replace first the lcd by a good one,if still no display we must therefore conclude that your display driver is defective..i hope it will help you ,thanks for sharing your problem with us and trustng fixya..
.

dude thats it mate game over

Friends,

Water damaged screen means total loss, You must have to chage screen. First time while you switch on it water is presented on TFT display, And its damaged to diplay & normaly is blank sometime. Check it in service center of it.,

Thanks.

If this continues, it may lead to internal damage which will cause the camera to not work at all from corrosion.