There is no image transfer belt on a Bizhub 350. there is one on a C350?????????????????
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
SOURCE: Reseting counter after installing new image transfer roller unit
You need to go into tech rep mode to reset.
press: stop 0 0 stop 0 1, then 0 0 0 0 0 0 0 0, press enter, then press counter on the left, select life, then highlight image trans roller and press the C button, repeat for paper dust remover and exit tech rep mode
SOURCE: Bizhub C450: After replacing the image transfer roller & ozone
In Service Mode -> Counter -> Life -> Select the one you want to reset and press 'C'
SOURCE: how do i replace the image transfer roller unit on
Periodical replacement for IMAGE TRANSFER UNIT is 150,000-print
1. Open the Right Door.
2. Pull down the blue knobs [1&2 ] forward and remove the Transfer Roller [3].
User Copy Operation Handbook page 5-9
SOURCE: how do i replace the
it is behind the right door but i doesnt need to be replaced you need a pico fuse about
$2 and it can be reset. if yoiu need more help in this and where the fuse is just ask
49 views
Usually answered in minutes!
×