My favorites on the tool bar is not there anymore,how do I get it

Underhood Electrical Center or Junction Block Replacement

Removal Procedure

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.


Click to Enlarge

2. Disconnect the positive battery cables from the underhood fuse block terminals.
3. Remove the tape from the wiring harness at the base of the underhood fuse block base.


Click to Enlarge

4. Release the underhood fuse block(s) clip retainers using a small flat-bladed tool.


Click to Enlarge

5. Remove the fuse block(s) and wiring harness lifting up from the base and reposition from the base.


Click to Enlarge

6. Remove the nuts from the underhood fuse block base.
7. Remove the underhood fuse block base from the shock tower.


Click to Enlarge

8. Remove the underhood fuse block lower front terminal positive assurance retainers using a small flat-bladed tool.


Click to Enlarge

9. Remove the plastic shields from the battery cable and buss bar terminals, using a small flat-bladed tool to release the clip retainer.


Click to Enlarge

10. Remove the bolts from the buss bar jumper bar.


Click to Enlarge

11. Remove the buss bar jumper bar from the fuse block(s).


Click to Enlarge

12. Remove the fuses from the fuse block(s) to access the buss bar terminal release tabs.


Click to Enlarge

13. Remove the buss bar(s) from the fuse block(s) using a terminal releasing tool, and pulling down and out on the buss bar.


Click to Enlarge

14. Remove the buss bar(s) from the fuse block(s).


Click to Enlarge

15. Release the clip retainers from the underhood fuse block(s) battery cable and buss bar terminals using a small flat-bladed tool.


Click to Enlarge

16. Remove the underhood fuse block(s) battery cable and buss bar terminals from the fuse block by pulling down.
17. Remove the fuse block and lamp wiring harness from the vehicle, if required.

I copied the info from my database, sorry, it is read only, The way I copied it, read only, no pictures.

If you right-click in the toolbar area (at the top where the favorite bar USED to be) you will see a small pop up with a few options. Click "Favorites Bar" and that should do the trick.

Alternatively, while in IE press the ALT key one time to reveal the Menu Bar. Select View > Toolbars > Favorites Bar

Hope that helps!

you can search the web for the 'google toolbar' and try to install it but you may have to use Google Chrome browser(install it from web) to use the google toolbar. why need that toolbar? you can attach google apps/tools to IE favorites bar, right? you don't have to use google search unless it is attached to the g tool bar?

You bookmarks are on the left sidebar.

Your Favorites Bar is the second line down on Safari. You click on "View" then you can click hide or show the favorites bar.

You can edit the Favorites Bar by two finger clicking the touch pad or right clicking the (Non Apple) mouse.
You can also drag the link to the trash can to remove it.

To put another link in the favorites bar, click on the link in the tool bar and drag it to the favorites bar.

Right click and chose delete

Right click on the Tool Bar (any where below the URL window) and find Favorites on the popup-menu and select it/click on it and it will automatically check Favorites. Once that's done Favorites will show on your Tool Bar.

Had the same problem. Went to the IE8 home page (Microsoft). They are supporting IE8 at no cost until Dec 31. Wait time was minimal, tech took control of my computer and fixed the problem you described in a few seconds. Sorry, I do not remember the exact steps.

Try the below.

Go to View->Toolbars.

Once you place your mouse over it, You can select any/all of the toolbars as per your requirements.This should bring back your toolbar.

Rate the solution as Fixya!

tnx,
AD

This is probably a fault in the colour demodulator circuits. You would have to give the set to a properly equiped and experienced tech to service this for you.

Jerry G.