Display lights, but is way too dim to see it.
SOURCE: Dim Display Panel on Sharp Convection/Microwave R-1851
its a common problem with the sharp microwaves. the control pcb needs to be replaced. it should come with the clock attached to it.
SOURCE: manual for sharp grill 2 convection oven
where is the fuse at on the sharp grill 2 convection
SOURCE: Sharp Convection double grill LCD
We repair those for US and Canadian customers, but in the UK you can contact Quality Electronic Repairs.
We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.
SOURCE: sharp carousel convection/grill/microwave maybe R990
Hello :
This happens because of a bad door switch . The plastic mounts inside
the microwave which hold the door switches and onto which the door
latches lock when you close the door .
Check also the turntable .
It could be out of it's right place .
WARNING :
1:Don't
slam your microwave door because this may cause the fuse to blow and
this is the reason of bad door switch problem .
2: A microwave is
capable of giving you a serious electrical shock even when it's
unplugged , so I recommend you to call a repair technician for help .
please
don't forget to rate .
good luck .
SOURCE: I have 2 Sharp R898M Convection /Microwaves , the
Open up the display and push on the end of the ribbon cable where it connects to the edge of the display driver PC board, if it lights up then your ribbon cable's connection pads are failing. REplace the ribbon cable. If it DOES NOT light up then you will need to replace the entire display assembly (driver board and LCD)
Click on the link below to view the Sharp R-898M operation manual (If you have lost your manual):
http://www.sharp.eu/cps/rde/xbcr/documents/documents/om/20_mwo/R898MA_OM_GB.pdf
1,311 views
Usually answered in minutes!
×