When put on the E4 error code is showing what can i do?
Good day
my dishwasher give e3 and e4. what is the problem and how can we solve the problem.
Https://www.justanswer.com/appliance/297sp-good-day-i-kelvinator-kd14ss-dishwasher-it-giving.html
Quoting from link shown:
"Sounds like the base of the appliance has flooded.
Unplug the appliance and drag it out.
Tip it rearward about 45 degrees, water will run out of the rear corners so a couple of towels would be handy.
Once drained, try the machine again.
If it's still tripping the power, you'll need to leave the machine switched off and allow it to fully dry out.
Hopefully, once dried out it should work again."
GOOD DAY HAVE KELVINATOR KD14SS DISHWASHER IT IS GIVING
Open the top lid of the Dishwasher. There are two screws at the back. Remove the lid and lift the "Protective Foam". The Inlet hose connection is there. Mine keeps popping off. The Clamp supplied on the machine is inferior. Change it for a "Screw Type" Clamp. This will allow you to tighten the Inlet Hose tighter. The reason the hose keeps popping off is because the Inlet Pipe is Just too short, and is always under Tension.
SOURCE: bELLING IDW604
i have just fixed my e4 code problem
take off salt cover and remove all water with tea towel or dish cloth you must make sure all water is out switch off at wall then back on if still e4 reapeat getting water out my washer is cleaning as i type
SOURCE: E4 fault code
Hi, when a dishwasher goes into overfill mode it usually means that the bottom tray has water in it that operates a float connected to a microswitch. Open the bottom panel and soak up all water then check to make sure the float is down completely.then restart dishwasher. Why it has overfilled is another problem. It could be a faulty pressure switch,pressure switch hose may have a hole in it, water valve may be faulty. Too much soap or wrong soap can cause too many suds and hence overfill.Also if rinse aid is spilt when filling. Or seals leaking. etc.
SOURCE: E4 ERROR
i have had the same problem,saw this add and got to it straight away,excellent info worked a treat,thankyou very much
SOURCE: idw604 error code e4
had same problem. Tilt dishwasher to the left and drain all the water (it will come out on the side). That's E4 solved. Now turn it on, E4 should not light up. If it does, turn it on and as soon as u do this, close the door. This won't activate the Trip Switch but will automatically turn the pump on. Good luck!
Good Afternoon friend, I appreciate your inquiry!
Typically on an Electrolux induction cooktop the "E4" error code stands for key sensor for timer. Which means you could be experiencing an issue with the right board, center board, or left board. I would perform a reset on your cooktop and you can do that by flipping the household circuit breaker off for ten minutes.
If that does not assist with clearing any false error codes or the error "E4" continues to display I would suggest seeking assistance from a professional for proper diagnosis and repair. Hopefully this helps. -Matt
3,839 views
Usually answered in minutes!
×