Replace the photo Conductor
SOURCE: How to replace drum unit
open right cover, and front cover. Remove toner bottle assembly (not just bottle), unplug drum (photoconductor) connector. Press the gray/silver release tab and slide out drum. Install and plug in new unit, replace toner assembly, close covers, and the new unit is automatically detected and calibration will begin.
SOURCE: Lanier LD225 Drum Reset
There is a small "flag gear" on the back that needs to be in the "up" position to contact the button on machine and initiate it when it is installed
SOURCE: Reset Photo Conductor Kit
Hi!
For step by step procedure to reset Photo Conductor counter please see the following link---
Photo Conductor Counter Reset
Please do rate this solution as FixYa and revert for further assistance.
Thanks
Rylee
SOURCE: My Lexmark E250DN said it needed a new
Whenever you replace the photoconductor unit, remember to reset the PC counter. With the printer powered on, open the front door/cover. Press and hold the cancel button until all the lights flash. This indicates that the photoconductor page count has been reset. Hope this helps. Thank you for choosing Lexmark.
420 views
Usually answered in minutes!
×