WhaDropped and won't turn on but still charges fine. Can hear a bit of rattling when shaken but not much.t's your problem?

When the Donvier is room temperature the fluid in the canister sort of 'rattles'. I think that is normal.

I need help! My son mx650 is charged, but won’t run. Put weight on it won’t move but lift rear tire off ground and runs full throttle

you are right about the bearing going to bits, it is called a CV joint. it allows the driveshafts to the front wheels to flex as you turn left or right and one is coming apart if one is going bad the other side will too soon, get them both replaced. If you don't, when it breaks completely it will cause MUCH more damage

Sounds like you might of broken the pressure / clutch plate. Are you able to hear the starter turn and engaging the solenoid ?

Hi there,

I'm sorry to hear you're having difficulties with your DC08. Due to the nature of the problem you've described, it's probably best if you get in touch with us directly so we can assist you in resolving it as quickly as possible.

You can call us free on 08002980298 - our Helpline is available from 7am until 10pm, 7 days a week. We'll look forward to hearing from you.

Kind regards,

Jack
Dyson Online Customer Support

Cut everything off for a few minutes then turn it back on and listen for a click from the compressor relay as the compressor tries to start.
Is the compressor motor running.If no check starter/overload relay. The relay is a small usually black cube shaped electrical part plugged into the compressor or wired to it nearby. It may appear burnt or rattle when shaken if it's bad. The two connections should show continuity with an amp meter. If it's good then it's most likely the compressor causing the problem.

tell nintendo

easy walk around see if car is stil straight and push all 4 sifdes bit down fast an watch the dampening effect. optical inspect for broken springsd or oil leakages too. Most quick fit carshops offer free suspension test. shakening and measuring. beware some rip-off joints might conclude all shot and sell you new tyres also

Get it replaced, the shaking noise can be a component from the main board that has broken off and it may have shorted out the board which is why it won't turn on. Get it replaced.

This type of thing has been reported for several different cameras. And it is considered normal. Some models actually rattle when you shake the camera a bit.