Saniflow wont pump

It is but this is something you must put up with. Make sure though everything is tightened well.

Here is a nice link for your saniflow maintenance.
http://www.plumbteamltd.co.uk/sanifloguide.html
This will definately help.

sounds like a stick float vave check this link on maintenance of your system.
Check the masserator is clear also check the outflow pipe , maybe a good clean see this link for more info
Here is a nice link for your saniflow maintenance.
http://www.plumbteamltd.co.uk/sanifloguide.html
This will may help.

This problem maybe caused by a slight weep of water from the cistern the saniflow has a sensitive float system , once level is reached the unit will turn on until required level is acheaved again . So check toilet bowl to see if the is a trickle of water if so you need to take a look at the flush system in your cistern.

Here is a nice link for your saniflow maintenance.
http://www.plumbteamltd.co.uk/sanifloguide.html

My Sanivite has packed up again (humming no pumping) for the third time, (7years old!) always the capacitor, don't buy from Sanivite get off ebay half the price.

The "Sensor" has failed, it needs to be repaired or replaced.

Open it up and give it a clean first .. fixes 90% of all ailments

could be a part blockage alowing water to filter back never put paper or towles in it

See if you can adjust the highth of the saniflow,to make it kick on sooner. goodluck.

Hi,

You need to check the following: Nothing connected to the saniflow is running e.g. tap dripping, ball valve in toilet cistern stuck/faulty

Any of these faults will cause the saniflo to run continuously. If none of these are visible then there is a chance that a flow switch is stuck or faulty within the unit.

I would carry out the checks first then call in an expert to service the unit.

I hope this helps.