Creative inspire 4.1 volume control 6 pin layout diagram

You would need to contact Creative customer support, but based on past experiences with this type of product they will want you to send it in for an exchange and won't sell the part, but give it a shot.

My sound system for creative 4.1 speaker volume control pin spoyel so how I use without volume control

It is possible. you can connect directly with male to male stereo cable. But careful with Volume, you must lower the volume in the playing device first.
The best alternative is
1. buy the cheap headphone with volume control or use Used old ones
2. Cut the Headphone Side and Solder the Stereo Male jack and plug it and Enjoy!

Speaker adapter is o.k. but no power, i cheked wires&on-off switch found o.k.

You didn't describe the problem so I hope the links below can help you. Good luck!!


http://support.creative.com/kb/ShowArticle.aspx?sid=65329
http://support.creative.com/kb/ShowArticle.aspx?sid=65329
http://support.creative.com/kb/ShowArticle.aspx?sid=2989

It's not sold separately so try to find on on Craigslist or Ebay - or any other sited that sells parts.

I think one of these links will get you where you want to be:

http://support.creative.com/Products/ProductDetails.aspx?catID=4&CatName=Speaker+Systems&subCatID=789&subCatName=PC+%2F+Home+Entertainment&prodID=446&prodName=Inspire+4.1+4400

http://ccftp.creative.com/manualdn/Manuals/TSD/2310/CSW1250%20CLE%20QSG.pdf

y do u opt for a replacment ? y dont u buy the cable its available at computers stores

sir i want creative 4.1 volume control wire please
[email protected]

For those searching the answer "How to replace/repair Creative Inspire 5300 volume control":

Its simple : looking at the back of the suboofer, the pins are as follows from top right, clockwise : LED VDD , Balance pot middle leg, GND, pots + legs, Volume pot middle leg, on switch input. Connect one pots ends to GND and the other ends to pots +, connect a switch on GND and on switch input, anode of led to LED VDD, cathode to GND (there is a 1,8k resistor inside so no external resistor needed)