20 year old admiral stove fuse panel - Maytag Admiral LER3330AAW / LER3330AAZ / LER3330AAB Electric Kitchen Range

go on line and type in admiral stoves
there are pages of parts suppliers
on the back of the stove or inside the inspection plate at the back there will be a decal stating the model and serial number of the stove

Get the schematic from Admiral with instructions on assembly for your model.

Get an electrician in, do mess about u could burn the hse down. Wiring probably cann't handle the specialist load.

Hot water valve needs replaced, (or check you hot water pressure)

You need to contact the landlord and I will tell you why: The stove should not have issues above and below simultaneously. I comment you for not wanting to bother the landlord but I feel like you have an electrical problem. The oven not there and the top not there? You have a bad circuit breaker on that puppy. Takes a 50 amp 2 pole 240 volt breaker for an electric stove and only qualified schocktricians should fool with them. My opinion.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

check the sensor. If open or grounded it could be causing this fault.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

I have an old Admiral gas stove and the same happened to me because the stove was not liting properly.The electric ignition may glow, but may be worn and not build up the proper resistance to open the gas valve. It can be checked for resistance with a multimeter. I found more help with this on repairclinic.com

all is off, power supply is good, pop the top lil lid (normaly very top) and look for fuses

that is a part number to the clock assy, assuming you have 110v to L1 on back of the clock and no display , that s a preyty safe bet youll need to replace that clock assy

What type of stove that was? Is that electric stove?
https://homzic.com/how-to-remove-electric-stove-burners/