20 Most Recent
Campbell Hausfeld PW2102 Gas Pressure Washer - Page 2 Questions & Answers
Will not draw soap solution
Follow the pipe back to the pump and you will find a ball and spring inside.This could well be stuck closed if it has been stored for some time. Oil this part and it should draw soap again.
6/24/2010 6:48:49 AM •
Campbell...
•
Answered
on Jun 24, 2010
Lose of pressure on Campbell washer
Usual cause is the pressure valve sticks closed and doesn't admit more water to be pumped. Usually needs new O RIngs and cleaning the bore... ABout a 15 minute job at most. Get an O Ring kit for it.
The valve is held shut when pressure on the output is high. When you open the trigger, the pressure drops and the valve opens letting more water come in from your garden hose.
The O RIngs dry out and bore gets dirty. Polish it with crocus cloth on a dowel rod. Lube the O Rings with lube intended for O RIngs.
5/8/2010 5:56:01 PM •
Campbell...
•
Answered
on May 08, 2010
When pressure washer is running no water is
Most of the time the problem is just debris in the spray nozzle. The hole is very small and it doesn't take much to clog it. If you can remove the nozzle, just take a pin or small piece of wire & poke it through the hole from the front of the nozzle and rinse it off with the hose. If the nozzle cannot be removed, just take the lance apart in the middle and do the same.
2/5/2010 11:38:07 PM •
Campbell...
•
Answered
on Feb 05, 2010
My 2100 will not pull up the cleaner solution.
THE DETERGENT HOSE USES THE VACUME FROM THE WATER MOVING THRU THE PUMP TO DRAW THE SOAP INTO THE PUMP.
CHECK THE AREA WHERE THE HOSE CONNECTS TO THE PUMP THERE SHOULD BE A SMALL BALL CHECK THAT MAY BE STUCK AND NOT LETTING THE VACUME PULL THE SOAP
9/16/2009 10:48:33 PM •
Campbell...
•
Answered
on Sep 16, 2009
I have the same problem...it has been sitting for a while
I have had the same problem, but with mine, all i have to do is start it a few times and let it die, and that warms the motor up and solves that problem. But also, if you look at the carb. when it dies, youll see that the throttle plate is on a spring and when the engine starts, because of suction, it imediatly opens the throttle all the way open, so with mine, I drilled a hole in the throttle plate and made it into a more controlable throttle so this wouldnt happen on cold starts.
9/4/2009 9:52:39 PM •
Campbell...
•
Answered
on Sep 04, 2009
Honda gvc 160 not starting. cleaned the ventui & plug
Check the fuel.
Drain some of the fuel into a white contain...I use a paint can lid. If it yellow to orange in color it's bad. You can pour the fuel into your car to get rid of it. A car has electronics that will compensate for poor fuel quality, small engines don't.
Check spark.
Remove the spark plug and reinstall the wire. Lay plug on the engine block where it can contact it. Pull over the engine. You should see spark. If not change the plug. If still no, I give you further instructions.
5/9/2009 2:25:15 PM •
Campbell...
•
Answered
on May 09, 2009
Not finding what you are looking for?