20 Most Recent
Whirlpool RBS275PD Electric Single Oven - Page 3 Questions & Answers
Did I damage electronics after using auto clean feature?
Sounds like there may have been a power failure or problem with the voltage when you were using this or before you did. Try shutting off the breaker for 5 minutes, turn it back on. This will reset the board in the oven. Then see if it works. If it still is defective, the voltage 'surge' may have destroyed the board. You may be able to turn it in to your insurance if that is the case, as from a storm that took out the oven when it hit and the power went out and then came back on. A clue is the keypad lights go dim and brighter then dim again.
3/6/2014 6:21:30 AM •
Whirlpool...
•
Answered
on Mar 06, 2014
Bake does not get hot enough
Look in your manual --- the temperature is preset at the factory but ----It may have changed somehow. You can see how to adjust your temp by using the instructions (trouble shooting page) or call the service center. It is an easy fix. If your oven is older, it may be that long copper wire in the back that is your temperature sending unit. You can get that replaced and that may be your problem solved
1/7/2014 3:55:55 AM •
Whirlpool...
•
Answered
on Jan 07, 2014
BAKE & CLOCK BUTTONS DO NOT REGISTER WHEN PUSHED- CLEAN & BROIL BUTTONS ARE REGISTERING
If your oven is a touch pad model then the pads are bad. the touch pad assembly will need replacing. Sometimes you can remove the ribbon cable and reinsert it. It sometimes will make them work but not very often. Make sure the power is off first. Remove the control panel. You will see the ribbon cable. There will be small tabs on each side of the connector plug carefully unclip these and remove the cable and reinsert it. Be prepared to replace the panel.
11/26/2013 6:51:43 AM •
Whirlpool...
•
Answered
on Nov 26, 2013
Reset cooker
Turn off breaker for 5 minutes and then turn it back on.
11/23/2013 3:27:48 AM •
Whirlpool...
•
Answered
on Nov 23, 2013
Not finding what you are looking for?