20 Most Recent
Power Acoustik PTID-8960 Car Video Player - Page 9 Questions & Answers
I have a power acoustik
It should just pop into that holder, it's possible it is worn out. It's pretty tough to say how to do it without looking at it... Any way you could take a few pictures of the setup and send them this way? Just post them on the comment here to start with... using the PICTURES button at the bottom of the text box.
Thanks
Tim
I have a PA A3000DB
This sounds like a cap breaking down to me, under a load. Ohming out caps doesn't stress them, and they can still read good. I would concentrate on the electrolytics, especially the larger ones, in the power supply, as you suspect. Depending on the age of the device, sometimes techs just go ahead and replace them all, just to ensure a solid, lasting fix, since caps are the only really time sensitive components.
Good luck, hope this helps, and thanks for using FixYa.
I have an spl 1440 watt model st2-1440 that goes
could be that the voltage that is going to the amp is to low or something is shorting out inside the amp if it is voltage then you need to add a secondary battery if that dont fix it then its inside the amp
I have a high power
the magnet size only matters for low tones, i.e. base, the larger the magnet the deeper the bass note, so no magnet size is not a factor with these used for mid range sound frequencies. The main thing is that the speakers are good quality brand with platic cones is prefered, a 4 ounce magnet will do the job
Blown 12inch 1800 watt
first you have to carefully remove the center with razor knife careful not to cut into the cone.you can hot glue this back on when finished. doing this will expose the the two thin sound coils one is inside the other now carefully apply a thin layer of vasoline between the two that way there not touching each other directly. sometimes a piece of paper works to, but it gives a small vibration sound when finished. when done just glue the center back on
Equalizer
Hi Sir
I Think You Should First Reinstall Your Car System And then you can try it again
if you are not successful in doing this then you should replace your car battery or check your battery terminals
thanks i hope it will help you
Help with code radio for my nissan pp2787h
The radio code is a security feature that's meant to deter theft, and it's unique to each vehicle. If you've lost your code, you'll need to contact a Nissan dealership or service center and provide proof of ownership. They should be able to help you retrieve the code. Please do not attempt to use codes from the internet as incorrect attempts may lock your radio.
Is there bluetooth on nsdn-w59
I have the same radio now with no Bluetooth am trying to get Bluetooth on it too without having to buy another radio. Please help.
No sound from wireless headphones in a toyota sienna
First thing to do is check to make sure that the batteries are properly charged.
Second, make sure that you have a clear line-of-site to the IR transmitter. Infrared (IR) works the same way that your TVs remote control works - if the signal is blocked, then you will not hear any sound.
Third, make sure that you are in the rear seat of the vehicle when listening to the sound. The IR transmitter only transmits to the rear seat, so you will not hear any sound if you are sitting in the front seats. This is a common problem that i see.
Lastly, make sure that the heapdhones you purchased are compatible with your 2006 2007 2008 2009 or 2010 Toyota Sienna. Remember that some older models require RF headphones, not IR headphones. I checked http://www.audiovideo2go.com for compatibility before I purchased my headphones. They have a useful listing of all the headphones and models of vehicles they are compatible with.
Not finding what you are looking for?