20 Most Recent
Jamo MPA201 2-Channel Amplifier - Page 5 Questions & Answers
I have a Jamo AVR-693
This problem is from the main board, if you try to remove the cover of your unit you will see the main board try to check the solder parts of the pcb. for sure you will see loosed solder or cold solder specially the filter capacitor and the power transistor. If you see this loosed solder try to resolder it but be sure to unplug your unit before opening the cover. before replacing the amp. lets make some basic trouble shooting who knows you might fix it. Feel free to send feed back best regards.
I have a Jamo surround
Since there are only two choices you could quickly try each of them. Or feed them both with the single LFE input and an RCA splitter.
I have a Jamo SW-410E
The unit has to be opened and checked for blown or bulged capacitor.If that is all ok then yes the transformer is to be replaced.The other possibility is blown AMP .It has to be checked with meter and confirmed.
Thanks. Keep updated for any more query. You can rate this
solution and show your appreciation.
I have a jamo S
Hi again Ray
Not sure what happened... I was about to tell you that some models of gear do not make it down under...
If you wish to pursue the fruitless quest for a board that can be simply repaired.... the Jamo distributor UK contack numbers can be found
here.
I would have been able to assist you with repairs to the board, if you had some knowledge of electronics for me to work with. I suggest that you contact them direct and enquire as to the warranty temrs for the gear. You left the call before I was able to
tell you that they have 3 years warranty here in Au...
Good luck.... thanks NOT for your patience.
regards
robotek
How do I change to degree mode on my porpo YH-2000
- Power Off: Turn off the device.
- Jumper Configuration: Locate the jumper labeled "S16" on the device. Initially, it should be connected to pins 2 and 3.
- Power On (Alarm+All LEDs Flashing): Turn the device back on. You'll see the alarm LED and all other LEDs flashing.
- Power Off Again: Turn off the device once more.
- Jumper Adjustment: Change the jumper configuration from pins 2 and 3 to pins 1 and 2.
- Finished: Your Porpo YH-2000 is now set to the desired angular unit mode.
If you encounter any issues, you can press the reset switch on the back of the device to reinitialize it.
Not finding what you are looking for?