20 Most Recent
Ricoh Aficio CL1000N Printer Questions & Answers
SC819 on Aficio CL1000N printer
SC819 is most likely a memory problem caused by a fault with the RAM or ROM modules in the printer. Replacing the faulty unit is the only remedy, and if it's the ROM, that's not going to be straight forward! Sorry it's not better news.
Service code 385
ID sensor adjustment error during process control self-check (this check happens when you switch on). Most likely cause is a dirty ID sensor, but there are other possible reasons. Start by cleaning the ID sensor and see how it goes from there.
How do i set up ricoh mp201on wireless network
you will need to plug in to wired network, disable dhcp and configure a ip address within your router range, then make a note of ip, reserve ip in router, removed wired connection and test on wireless.Thats is all done.
How do i get an ip address from the computer to
StartRunCMDin CMD window type ipconfigmake printer the same ip address but add 1 to the last 3 numbersif the address of the PC comes back 192.168.0.25make the printer 192.168. 0 26 for example
Printer keeps saying it has
This error message is displayed by the printer when paper is jammed in one or more locations. In such a case, users are recommended to remove the jammed paper from the specified location. The entire paper path must be checked for any pieces of paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor or sensor lever.
On a ricoh aficio CL1000N, what does the error
There is no sc922 for the CL1000N, but sc992 is a general software error. It typically shouldn't interrupt operation, but it if it does and it happens more than once, try to figure out what you were doing when it happened. Were you printing a big job? Were you printing a job with a particular font? Does it always happen at a certain time of day? Narrowing down the conditions can help to figure what is causing the error code.
Aficio CL1000N Printer: On my Ricoh aficio CL1000N it says add toner Cyan....
If I remember right, the CL1000 won't print if any of the 4 colors are out. You have to replace the cyan toner in order to print, even in black and white.
If you haven't tried already, you can try taking the cyan toner out and shaking it up (just a little bit) to try to get the printer to find the little bit of toner left in the bottle.
Not finding what you are looking for?