Kohler 20RESAL 20 Kw Generator - Page 5 - Answered Questions & Fixed issues
How to clear a main power overload on a kohler gen
What is missing here is a couple of things, what size generator are we talking? a residential, commercial, what control is on the unit. They all reset in different ways. One sure way is disconnect the battery charger first (VERY IMPORTANT or control board can be damaged) disconnect the negative terminal off the battery. leave off for a minute they re conenct and re energize charger. Fault should clear unless you have done damage due to over load.
3/2/2015 6:43:25 PM •
Kohler...
•
Answered
on Mar 02, 2015
•
1,138 views
Kohler 40 kw adc controls troubleshooting
wow intermittants are tough to find , the only way ive ever been sucessfull at it is to temp bypass each sensor (lie to controller) to see if it continues to run ,I do not recomend leaving any thing bypassed and not physicaly monitoring it ,
this temp bypassing is for only the most experienced techs that know normal state of sensors and can simultate them with off machine items
1/30/2015 3:12:31 AM •
Kohler...
•
Answered
on Jan 30, 2015
•
154 views
Why does my generator start constantly?
if a lightning strike was anyplace close (30 yds) it's a safe bet your gonna have to replace the control board in generator also Id have a qualifyed tech ck out your auto transfer switch ,I bet he''ll find that you fried your coils on your switch too , do that before changing control board cus if ya hook up a new one to a bad coil ya just bought two of them
6/4/2014 11:32:42 PM •
Kohler...
•
Answered
on Jun 04, 2014
•
249 views
Kohler 6eod
Under voltage would be low output voltage from the generator power head. Verify that the motor is funning at full speed to check the output voltage.
Low battery is telling you that the starting battery has low voltage. This could be because the battery is bad or that the alternator is not charging the battery
5/23/2014 5:58:43 PM •
Kohler...
•
Answered
on May 23, 2014
•
328 views
First start up
Try disconencting the remote start wires between the transfer switch and the generator, if ot still does it you have a bad control board. If it stops, then check the transfer switch for correct wiring of utility and generator power wires, also check with an ohm meter if the run contacts in the transfer switch are closed, that would indicate loss of sensing, or bad board
12/1/2013 10:51:28 PM •
Kohler...
•
Answered
on Dec 01, 2013
•
205 views
Not finding what you are looking for?