20 Most Recent Campbell Hausfeld PW1750 Electric Pressure Washer - Page 2 Questions & Answers

Replace the wand (Gun) The valve is not repairable.

With the water faucet turned fully on and the power switch on squeeze and hold the trigger for at least 10 seconds to let the water flow push the air out and then it should start up.

The problem sounds internal (perhaps the temperature cut-off switch or the auto-start-stop switch). For safety and possibly warranty reasons, you should not open the case to investigate or repair; take the unit to your local service center.

looked up Campbell Hausfield service on internet. found dealer within 1 mile of home.

water pumps doesn't require oil in the pump; but your engine does require. if the water pump is of "self priming" type, fill the pump casing with water before starting the machine to avoid damage to the water seals.

Sounds like a coil.Run till it shuts off, then check for spark.If there is no spark you will need a coil.

Hook up the water hose and plug it in I assume it is electric.

cuff kit for the pump housing a service manual but it could together sometimes expensive , look at the plungers they must be stainless ,before the dicision ,The age for a pressure washer depends mostly on the speed range mostly in two speeds in 1600 or 2800 rpm. a 2800 rpm is usually an entry level model and an age of 7 or 8 years on average. the 1600 rmp and with a brass pump is a quality product, and if its COMET Kraenzle DIBO INTER PUMP than it pays,, in your case http://www.partselect.com/Models/PW165001LE/#Parts

2 possibilities. It is not getting enough water from the hose or your pressure regulator is bad. Does it sound like the engine is developing full RPM? Could be and engine problem if not coming up to full speed.

Because the seals are shot and need to be replaced.

common for not starting unless trigger engaged as you are turning the pump as well as engine creating pressure,as for stalling pump has unloader valve which is probably in need of grease(use good silicone grease)this allows water to ciculate when trigger released.