Dear Sir:Please do it with a pencil under the display board. There is a small orifice, and with the point of pencill tocuh and then turn on the machine. sincerely. God bless you.ernesto cuadramanagua, nicaragua. c.a
the best way is read you instruction manual, for instruction about this notification.2) You must Lube the deck belt, by lack of maintenance you can have this notification. 3) Lube the rollers bearing.4) Download the instruction manual if you do not have www. fitness.manualsonline.com or www. iconservice.com5) Run the software calibration for diagnose and troubleshooting.God bless you
Dear Sir:Please Run the software calibration for easy diagnose and troubleshooting. You must inpect and measure with your VOM, if the input voltage is 115-120Vac range +- 10% of tolerance if the voltage is minus 10% lower you must check your outlet wall in your hour and repair the ground and the problem call some electrician and Install stabilizer voltage. Do no use ANY power extension for your machine. sincerely. God bless you.ernesto cuadramanagua, nicaragua. c.a
Buying tiny screws for almost any device are pretty easy to get at places like this. Home depot or lowells, Most major stereo shops like CAR TOYS, also believe it or not a lot of watch places, that sell and work on watches and finally another place you can buy them is places that sell eye glasses and sunglasses. In hope this helps, bring your device in to have them match it up. Thanks Mike
The Lifefitness Lifesyscle 9500HR battery location is at in the lower portion of the recumbent bike.
This is a 1/2 to one hour task for most do it yourself'er.
In order to gain access to the battery compartment,you has to remove the pedals.
The center cover has to be remove.
The 6V battery will be within 12" from the pedals.
Additional reference:
Lifecycle Battery 0819-0012
Model
Description
Terminal
Volts
AH
L
W
H
Lbs
Price
0819-0012
Fits Lifecycle Stairmaster series 4200, 4400 - Lifecycle Lifefitness CT8500, CT9100, 9500HR, 95Ci - Star Trac 5300/6300, 5400/6400, StarTrac 6100 Pro, 6200 Elite, ET4600 (0819-0012 replaces the 0819-1006)
F2
6
2.5
4.48
1.81
2.75
2
$19.80
Hi there, here is a website that seems to list many parts for this particular model, hopefully you can add up whether it is worth doing or not. What you need to think about is what actually may be needed, whether it is just a drive gear, the drive belt or a multitude of parts. If it costs too much to repair then you may want to think about putting your money towards a new one. I think in this caseyou may be lucky as it sounds like it is just the drive belt that may have worn and lost a few teeth.
hi check the home switch it is indicator of elevation when you look under the tredmill where elevation motor you will see white plastick pin coming down through the hole just check it if still there and pressed it is usually 95 % of elevation problems
if it is not then open the hood and check elevation connections
let me know if it is not these problems post it i will give you system check code thank you and good luck
