Started hearing alot of top end noise, Valves are in spec ok, But did notice some metel dust on the outside end of the intake cam lobe. Can anyone tell me what i am looking at. I have a 2007 RMZ 250 ...
...bearing.ihave taken barrell off.should con rod have slight movement side to side The rod should move side to side this is called little end side shake. the correct amount is .8mm to 1.3mm make sure ...
...rod is shaking,it has to be replaced,to replace he has to open the engine,once it is opened,the whole engine kit has to be changed.is that right ???? Yes. He will need to split the case to get the ...
2007 Suzuki GS500F, Starter problem I have a 2007 Suzuki GS500F. My problem is that the starter really labors to start the bike and if it doesn't start pretty quick then the battery will be too weak ...
...burned creating smoke. In a two stroke engine the gearbox oil does not come in contact with the crankshaft, connecting rod, or the cylinder. The two stroke oil is mixed into the gas and gets sucked ...
bearing companys can match it up or buy new one online easy way to remove the seal is remove shift lever drill small hole ner shift rod threw the seal dont go to far just make it threw the seal scew a
Question about Suzuki RM-Z 250 Motorcycles
1976 KZ900 Z1 CLUTCH KEEPS GOING OUT!! 1ST TIME THE BEARINGS IN THE ACTIONATOR WENT BACK CAUSING THE CLUTCH NOT RELEASE!! HAD A NEW ONE PUT ON AND WAS FINE FOR A DAY OR 2 AND DID THEY SAMETHING AGAIN!
96 questions posted
Usually answered in minutes!
67 Questions
0 Questions
2 Questions
1 Questions