...dont drip it anywhere or it will damage your paintwork,also do NOT pull the lever in yet,then fill it 3/4 up with new fluid ,then put a spanner on the bleed nipple on the clutch slave cylinder on the ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...to set revs and the mixture but it runs better for a certain time it also seems to cut out when you dont have revs on ? Carbs should be left alone apart for basics in revs. I would up the tick over ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...WERE REALLY CAREFUL, CLEANING THE FILTER, OILING ETC ETC, BUT OBVIOUSLY NOT GOOD ENOUGH you realy dont wont much do you!!! keeping sand out the engine??? bam near impossible all you can do is fit a ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...i could hear it slowly breathing out the fluid from the black box on the top part of the bike.i dont know where to get the seal from? i hope you can help me.. sound like the master cylinder needs ...
...contain two screws( should be brass) idle jet and main jet. Undo and take these out one by one, dont get them mixed up. check them against a light source to see if they are blocked. If they are ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...breathe dont take off! keep prying..if you cant get it all the way flat then try a c-clamp to squeeze the brake pad cylinders all the way in flat no take out the bolts that hold them in place and ...
...OR K N.COST 50 TO 60 IF YOU GOT THE MONEY GET THE ARLEN NESS PACKAGE OR HYPER CHARGER,THOSE BIKES DONT BREATH WELLALSO CHECK YOUR TAIL PIPES ARE THEY WET OR ALOT OF RESIDUE.IF SO THAT IS SIGNS OF ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...can be the problblem new plugs new oil new fuel pump new battery a few people i know that ride but dont have yamahas new fuses Hey man, pull the plug wire off to see if there's spark when u crank it
dont leak ive put a new spark plug in to First what kind of noise. Plus did you replace the cam chain tenisor when you replaced the chain. That will make a noise in the top end. Other than that piston
...is a nut welded on bottom of steel gas tank. there is not. i ordered a new petcock from honda but dont under stand what it would thread into. there is just a 1/2 in open hole at bottom of tank.
67 questions posted
Usually answered in minutes!
175 Questions
86 Questions
60 Questions
52 Questions
44 Questions