...no it won't run only when I hold the throttle on high RPM's and it feels as if not all the cylinders are working, what could I possibly did wrong?? not sure maybe the ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
my 1997 vulcan 1500a has smoke coming off of the front cylinder exhaust, is this from the bike getting too hot? If so, is there a temperature gauge, or light on this bike somewhere? When the bike runs
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
engine stops running on one cylinder appears to stop after it has gotten hot electrics can age on old vehicles--coils,modules etc get hot--do a test on components--plug wires may be worn--secure a ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...cylinder at top run low while you are doing this. After a 10 minutes or so, tighten slave then refill cylinder and do the old pump and drain bleed a few times. I found that it works better with the ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
run great i change oil when she needs and do annual services on her. With out warning she went to backfireing and not running rite, she will idle and throttle up great but put her on the road she pops
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
1500 kawasaki vulcan leaking gas into cylinder could be 2 problems, the carb float needle should stop the flow before it floods into cylnder, so it may need a clean or replace. If it floods when ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
cylinder. To run on today's fuel most bikes have pistons with compression ratio's designed to give acceptable performance using an 87 octane graded fuel, this means the average compression readings on
...cylinder on the left hand side of the engine ,then put a clear pipe onto the end of the nipple and get a small coke bottle or similar and make a hole in the cap which is a snug fit for the pipe push ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
how to prime the slave cylinder? you can use a brake bleeder on caliber. leave cover of slave cyl. to keep it full. do not let it run dry.
67 questions posted
Usually answered in minutes!
175 Questions
86 Questions
60 Questions
52 Questions
44 Questions