...microwave on top and oven bottom built into a cabinet. I cannot find any model number other than when I open the microwave and it is Model 665.4438993 built in 1990. The unit has two manual dial for ...
...built-in unit (model SCB1001KSS) that has no apparant way to remove the control panel to get to where I believe the bulb sits. I imagine you need to pull the unit out, but that won't be too easy. I'd ...
How do I Unlock my oven I pulled the heat sensor to replace it and when I shut the door the oven locked and will not open. I get an error cod of F3 which means the sensor is bad, but I cannot unlock ...
...built in. ok the meat probe error is the meat probe is wired backwards yor microwave is a blown fuse in line with the primary interlock switch send me an email at [email protected] can help the primary ...
...built in ovens is the error code "F7? shown on the display. I've seen it many times before and today I had a service call for the same problem again. The error code "F7" will be displayed along ...
...microwave combation that has an error code F2. What does that mean and how do I fix the problem? Thanks The F2 Error code means the oven has detected an excess temperature condition. Most often this ...
...oven will not heat, circuit fuse is OK You will have to remove the unit, to access the back and pull the covers, most likely you coil is burned out. Or a safety fuse to the coil is tripped last ...
...built in broil and bake unit where you would pull the pan out from the top?! If so, I don't know! :o ....but based on my experience in making pizzas, I strongly recommend that you put it on for 5 ...
pull the entire unit out of the wal with the power off at the circuit breaker, remove the backing panel, and disconnect the wiring to the probe. Some units you have to remove a side panel instead. You
44 questions posted
Usually answered in minutes!
343 Questions
26 Questions
20 Questions
13 Questions
8 Questions