...crank do I reuse old rod bearings or replace with new? car is not long for this family. Going to be a trade in. Yes you can remove the pistons without removing the crank. All you need to do is make ...
torque wrench settings for crank and main on 94 2.2ltr camry. please :0) Which motor and what are you specifically needing the Torque specification for. "crank and main" is not specific enough. Is it ...
...set the couiter balanceto the crank? TKS. THE CRANKSHAFT VIBRATION DAMPER CRANKSHAFT THROWS AND FLYWHEEL ALL BALANCE THE CRANKSHAFT.IF CRANKSHAFT OUT OF BALANCE AND VIBRATION GOOD AND THE CRANKSHAFT ...
...Set the the engine to Top Dead Center before removing the old belt. If you've already removed it with the timing in any other position, do the following:- Rotate the camshaft so that the drill ...
Set #1 piston at TDC, Loosen tensioner w/ spring slip off belt. **Remove sprocket pull out old seal with a sharp pick. Greese and install new seal make sure its flush with its bore . Reistall sprocket
crank replacement -- along with full set of bearings -- is going to have to happen. Unable to locate crank or bearings and possibly piston. Talk to an engine rebuild shop near you. They should be able
Question about Cars & Trucks
cylinder, main bearing and crank cup torque settings on a GWM cb 150 vvt here are the torque settings for the cylinder, main bearing, and crank cup on a GWM CB 150 VVT: Cylinder: 40 N-m (29 ft-lb) ...
does anyone know the crank main bearing nut torque Alfa V6 3l does anyone know the crank main bearing torque setting for a Alfa romeo 3L V6 engine Torque to 25Nm, then tighten through a further 79 ...
Question about Cars & Trucks
...bearings there different sizes unless the crank was turned I've built hundreds of motors and toyota want to keep the aftermarket out of there engine marked on the fromt of the block and the middle of ...
Question about Cars & Trucks
...crank and conrond torque settings for a nissan RB30et and what the ring gap set that I'm rebuilding a standard nissan RB30et and I need to know what the torque settings are and how much ring ...
2,531 questions posted
Usually answered in minutes!
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions
1,141 Questions