...Remove front right wheel, - Remove brake caliper, pads, caliper hanger, - Remove the wheel speed sensor (even if no ABS), - Remove the two large strut bolts (100+ lbs ft/lbs of torque), - Remove the ...
front wheel bearings on a 2003 Hyundai Tiburon? Thanks u will need to remove the brake cailper and the the brake rotor, then the hub retaining nut, that is a large metric nut, the bearing and hub must
Question about Hyundai Tiburon
...front wheel bearing ceased to brake disk car was making small intermittent noise.took to garage ended up with bill for nearly £500.They said caliper had broke which in turn was the probable cause of ...
front wheel bearing 2003 tiburon how do i get the sensior off so i can take the bracket in to get the old bearing pressed out at the shop There's one bolt holding the sensor in to the steering knuckle
Question about Hyundai Tiburon
front wheel bearring on 2001 Tiburon,can I get diagrams for this on line ?? Or IS THERE A REPAIR MANUAL ANYWHERE for my 2001 Tiburon ?? PLEASE help !!! Yes autozone.com has a repair guide for your car
...remove ,but damages the bearing. Best to buy bearing and have cash for an alignment job too.Then replace front rotors. Rotor and hub install is ez after you get bearing pressed.Rear rotor and bearing ...
front wheel bearing.Garage heated to remove and cracked fairly new wheel disc.After they fitted new disc the car failed their brake test ,so they removed everything and found problem with something to
...remove front wheels remove brake calipers remove front rotors and cv axles remove steering hub assy from lower ball joint,tie rod end and struts take hub to shop and have bearing pressed out have new ...
...Remove front wheel hub assembly with suitable tool. 3. Remove retaining ring. If the bearing inner race remains on wheel hub, grind a section of inner race until approximately 0.020 in (0.5 mm) ...
...remove the front wheel bearing on my 1993 ford escort? Service and Repair Remove front hub/steering knuckle assembly from vehicle. Position front hub/steering knuckle assembly on a press and press ...
563 questions posted
Usually answered in minutes!
976 Questions
206 Questions
135 Questions
110 Questions
80 Questions