20 Most Recent 2006 Hyundai Tiburon Questions & Answers


Check with the application catalogue of your choice of oil brand and you should find your car listed with the appropriate grade of synthetic oil.

There is a note of caution, especially with an engine that has already covered a fair mileage. Depending on the service history and the type of oil used in the past, the engine could be clean, slightly dirty or very dirty inside and changing to a high detergent oil if the engine is dirty could cause problems. Detergent oils scour the inside and cleans things and holds the dirt in suspension so it gets drained at the next oil change.
The trouble is, there is a limit to how much dirt the oil can hold and if that limit is reached mass dumping can happen - blocking filters and oilways.

It is a while since I encountered an engine that died of a thrombosis and the additive packs of oils have been improving all the time but the point should be considered...

2006 Hyundai... | Answered on May 05, 2019


Removal & Installation

Specific to:
Hyundai Entourage 2007-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Disconnect the negative (-) battery terminal.
  3. Remove the crash pad lower panel (A).

    0996b43f80e41e86.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the crash pad lower panel (A)
  4. Remove the 2 screws (A) and the trip switch connector.
  5. Remove the crash fascia panel (B).

    0996b43f80e41e87.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the crash fascia panel (B)
  6. Remove the screw with the ignition in the ON position (IG ON) and disconnect the 6P connector.
  7. Remove the ignition switch (A).
  8. Installation is the reverse of removal procedure.

    0996b43f80e41e88.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the ignition switch (A)
Specific to:
Hyundai Accent 2006-2008
Hyundai Azera 2006-2008
Hyundai Elantra 2006-2008
Hyundai Sonata 2006-2008
Hyundai Tiburon 2006-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    The negative battery terminalThe crash pad lower panelThe ignition switch after loosening the screw with IG ON and disconnecting the 6P connector
  3. Installation is the reverse of the removal procedure.hope this helps it is off autozone website

2006 Hyundai... | Answered on Jun 29, 2018


Good transmission shop, $750-$1000. Dealer probably much more, they can tell you.

2006 Hyundai... | Answered on Sep 29, 2017


master cyl could be losing pressure internally, if slave is dry that is most likely problem

2006 Hyundai... | Answered on Oct 09, 2015


If you mean O2 sensor, bank 1 is the driver's side on RWD, or front bank on FWD. The #2 sensor is the one behind the catalytic converter, which does little but telling the ECU if the converter is doing its job.

2006 Hyundai... | Answered on Jul 22, 2015


Get it towed to the dealer -- it is too DANGEROUS to drive a vehicle with such a DEFECT. The life you save may be your own.

2006 Hyundai... | Answered on May 10, 2015


Do you smell gas when your outside the car? Say hood lifted and a strong smell of Gasoline?

2006 Hyundai... | Answered on Mar 11, 2015


Spark plugs, vacuum leak, rank sensor, air flow sensor.

2006 Hyundai... | Answered on Mar 10, 2015


Check to see if your vehicle honks when you press the "lock" button on your key fob. Press the "lock" button multiple times in a row. Many devices won't beep unless you double-tap the button after locking. If the horn doesn't honk, but the lights flash, your chirp feature is probably disabled.

Use your keyless fob and ignition key to enable the audible chirp. The process varies considerably on different makes and models. You must usually consult your owner's manual, a dealership or the alarm manufacturer for the correct process.

2006 Hyundai... | Answered on Jan 29, 2015


SORRY BIT IT SOUNDS LIKE REBUILD TIME TO ME

2006 Hyundai... | Answered on Dec 19, 2014


no fire on plugs you say? check voltage coming off coil pac

2006 Hyundai... | Answered on Nov 20, 2014


OEM were these
http://www.carid.com/2006-hyundai-tiburon-brakes/powerstop-1-click-oe-replacement-brake-kit-31487698.html

2006 Hyundai... | Answered on Nov 04, 2014


No such thing as resetting those sensors

If the Oxygen Sensors work, the check light on the
dash will go out when the Emissions Monitors Run
for that system

You have 8 I/M Monitors that have to run clear before
you can go to inspection

Have a shop road test with scan tool to check that & make
the required repairs

2006 Hyundai... | Answered on Sep 07, 2014


Try a gallon of gas, you may have a bad guage.

2006 Hyundai... | Answered on Jul 09, 2014

Not finding what you are looking for?
2006 Hyundai Tiburon Logo

211 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Tiburon Hyundai

  • Tiburon Hyundai

Most Popular Question

removing harmonic balancer 2 7liter v6

  • Cars & Trucks
Loading...