...Replace the crank sensor and all will be good in the world again. With the key on and drivers door open, disconnect the crankshaft position sensor. You may hear the chimes, buzzers and other things ...
...door needs to be lowered to access. if blower does not work on any speed there is a fuse panel on drivers side by brake pedal under dash. i believe that contains fuse for blower motor should be ...
...replace the rods for the rear window; and then took off the interior of the rear door and nothing. I do notice that when I am going down the freeway, the truck will `sway' a bit back and forth when I ...
door hinges, check links, hood and sunroof (if equipped). ? Replace the engine air cleaner filter every 36 months or 30,000 mile (50,000 km), whichever occurs first. An Emission Control Service . (See
...replace the motor? If you hear the motor turn or try to turn the regulator cable is most likely snapped and wound up in one of the pulleys. You will have to remove the door panel and cut the cable ...
...door switch replacment The driver side window switch stopped working. All other parts of the console work normally. Have tried to replace the switch module, but three different units all have not ...
...Check the rods that links the actuator to the door lock knob.If you are unsure what to do. just bring your car to a shop. its just a 30 minute job. =) The acuator inside the door is getting weak and ...
Question about Jeep Grand Cherokee
...trim panel and with the aid of a wiring diagram, if possible, verify the motor is working by providing a completely independent supply and ground and if it is continue to check the wiring to the
...door V6 4X4, any help email me wiyh answer or link at [email protected]. Thanks. What does that mean? The P0410 code refers to the emissions system. The AIR pump puts air to the exhaust to lower ...
3,696 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions