1996 Jeep Grand Cherokee "limited crankshaft" Questions

...limited crankshaft crack? I believe my 1998 grand cherokee limited crankshaft cracked and led to 1) my powersteering leaking out entirely and 2) belt on front of engine to come off. I am not sure if ...

...limited 4.0? 4.0L The Crankshaft Position Sensor (CKP) is mounted to the transmission bellhousing at the left/rear side of the engine block. Engine speed and crankshaft position are provided through ...

Cranking but not starting jeep grand Cherokee limited v8 4.7 Changed the crankshaft and camshaft position sensors First check for spark at any of the sparkplugs.

JEEP CODES P1391 AND P1398 p1391= crankshaft / camshaft position sensor intermitant signal, check, wiring, connections & sensors p1398= engine control system missfire detection limit reached ...

Crankshaft paper I have the same problem with my 99 grand cherokee limited stalling out at lower speeds such as taking off from stop lights and such. I have been searching high and low for a solution.

jeep stutters and 1st to 2nd gear change when i start my jeep it stutters for a couple of seconds and then goes normall. also when i add gas right to the floor it wont change from first to second gear

limited 4.7 motor knock, what are some of the coomon problems with this motor? First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem

...limited 4.7 l The camshaft position sensor is located inside the distributor. It is a hall effect swich, simply remove the distributor cap and the rotor and you can lift it out, unplug and replace. ...

...Limited. The mecanic has already check the two cover screws on the PCM, the distribtor cap, all spark plug wires & plugs, battery and battery connectors and changed the Crankshaft Position ...

...limited V8 4wd, when i turn the key, the starter clicks but wont turn over. I replaced the starter and checked the battery and the ground connection. all are ok but i still have the same problem. Is ...