there's no antifreeze in engine oil, replace sending unit. Should be a round silver sending unit at the left rear place on the intake with a plastic black wiring connector with 2-3 wires going into it
Question about Chevrolet Silverado 1500
...oil pressure sending unit above the filter 2) "o" ring between the oil cooler and block on ex models only. the oil cooler is between the filter and block with 2 coolant hoses attached to it. also ...
Leaking oil pressure sending unit. This small round unit is screwed in to the block and has a wire or two attached to it. 2) Leaking valve cover gasket. Oil runs down the side of the block. Be blessed
Question about Chevrolet Silverado 1500
...oil pressure sending unit on my 2007 Pontiac G6? I was experiencing oil leaking and after having my oil changed by a local oil change expert, he found that the leak was coming from my oil pressure ...
oil sending unit 1 or 2? bad oil leak, saw one sending unit above oil filter, is there another? I'm not sure but, you may need to check your PCV valve also.
Question about Chevrolet Silverado 1500
...oil sending unit and approx. inches above the pan(oil) on most cars get it clean, drive around the block then look, the gasket that leaks is the cause. replace it. gasket ,o-ring or seal. or use the ...
...oil pressure sending unit has gone bad. It's a simple fix, locate the oil pressure sending unit (between the starter and oil filter are) and replace. Auto Zone will have the part you need and step by ...
Question about Chevrolet Silverado 1500
...oil sending unit on my 2008 Pontiac G6 as it is leaking oil, but am having trouble determining the right part #. Is there an oil sending switch AND a separate oil sending unit? there should be a ...
Question about Chevrolet Silverado 1500
OIL PRESSURE SENDING UNIT FOR OIL LEAKING AROUND AREA WHERE IT THREADS IN THE CYLINDER BLOCK.OR YOUR OIL FILTER SEAL COULD BE LEAKING.REPLACE OIL FILTER SEE IF YOU STILL HAVE A OIL LEAK.THEN IT HAS TO
...the oil sending unit. The housing is mounted by 2 bolts A defective gasket seems to be the problem... IT ALSO HAS A GASKET ON THE SENDING UNIT, LUB THE NEW UNIT BEFORE INSTALL, THE LAST GUY ...
546 questions posted
Usually answered in minutes!
4,236 Questions
159 Questions
130 Questions
67 Questions
56 Questions