2004 Chevrolet Malibu "classic change spark" Questions

...Classic, and I changed my spark plugs & oil, and now it want start. My car was working fine until I did all of that. It sounds like it wants to start but it want. you crossed one of the spark plug ...

...classic 2.2 L turns over and is getting fuel but won't start. sounds like crank sensor, but unplug mass air flow sensor on air filter tube see if it changes condition need to check if you have spark ...

classic cuts out sometimes while driving down the highway, does not do this when I press on the gas, also idles rough especially while in drive If your car has over 100K on it, you will need to go and

...classic. 4.3 engine. i am going to change the spark plugs but i just want to know where all of them are located. thank you. Here is a diagram of the engine cylinder layout, just match up the numbers ...

...a 2004 Malibu Classic which hesistates on acceleration already changed spark plugs, air filter, gas cap. on a v-6 change the spark plug wires on a 4cylinder check the coil pack and the ignition ...

...classic would not go pass 40km per hour and the speedometer will not raise from zero i ve changed the spark plugs and the transmission fluid but still the same problem Any codes?Did you check speed ...

classic (5.7ltr) engine turns over but won't catch. Possible solution? if it was running fine before you changed the cap and rotor just make sure you put the spark plug wires back in the same spot

change the spark plugs on a 1995 chevy caprice classis. How long should it take to do the job. the local shops want to charge me $120.00. I think that is crazy. thanks just remove one of the old spark

...classic take it to the shop and the problem goes away till you drive it home again. I would start with checking for loose connections, you would need an electrical diagram to see how the ignition is ...

...Classic 350 V-8 engine, they will come in the box pre-set to about .035, which is the proper gap. ( I do not have these numbers memorized). About the only time you would change the factory setting is ...