1994 Buick LeSabre "3 cylinder head bolt" Questions

cylinder head. hope this helps, Torque sequence --------- front ' 6 1 3 7 ' of ' ' engine ' 8 4 2 5 ' --------- Step 1: torque bolts in sequence to 37 Ft/Lbs Step 2: torque all

...bolt torques spec 1999 Buick Le Sabre 3.8L head bolt torques spec 3.8L V6 cylinder head bolt torque step 1 37 ft lbs. step 2 an additional 130 degrees step 3 4 center bolts an additional 30 ...

...ignition control module ... the ignition control module is mounted to the left cylinder head. more precicely, under the 3 coils Remove coils , remove harness bolt, unplug harness & remove ...

...3.8L V6 connecting rod torque step 1 20 ft lbs. step 2 an additional 50 degrees cylinder head torque step 1 35 ft lbs. step 2 an additional 130 degrees step 3. 4 center bolts an additional 30 ...

3/8 of an inch above the surface. Many, many little peaks, be careful not to leave any silicone on the inner pump surface as it will break free and get stuck where you don't want it(like in the heater

3 hours later and nothing at all checked battery,passkey and starter there all good security light does flash and I can't figure it out please help 93 buick lesabre If your security light flashes when

...3 2 6 10 EXHAUST SIDE In sequence, torque the cylinder head bolts. Torque: 30 Nm (22 ft-lbs). In sequence, torque all bolts. Torque: 50 Nm (37 ft-lbs) In sequence, turn each bolt an additional 90 ...

...3.0 6 Cylinder Torque sequence ---------- ' 6 4 2 8 ' ' ' ' 5 1 3 7 ' ---------- Step 1: torque to 59 Ft/Lbs Step 2: loosen in sequence (1) full turn Step 3: torque to 41 Ft/Lbs Step 4: torque to 73 ...

the cylinder head. 3. Lubricate the bolt threads and seat surfaces with clean engine oil and install them. Torque the bolts in 2-3 steps to 56-60 ft. lbs. (75-81 Nm) in the proper sequence. Hope helps

...cylinder head bolts in 2 or 3 steps in the sequence shown to 76-81 Nm (56-60 lb-ft). 1.9 liter Apply a light coating of engine oil to the threads of the new cylinder head bolts. Install the new ...