Question about Chevrolet Malibu
...wont drive forward it will only move in reverse. What is the problem? Is it an automatic? If so its most likely to be an electronic shift solenoid. Unless your mechanically inclined do not attempt ...
reverse, but not drive. It attempts to move forward if you hit the gas in drive, but wont move, just kinda "leans" into it. I opened the pan and it was mostly black, while the filter had a red tint to
...wont move in drive but will go in reverse. At times I can get it to move but when it acts like it wants to pull it starts jumping like the gears are slipping. Could that be my converter or my gears? ...
Question about Chevrolet Malibu
...wont move in drive but pulls good in reverse i bought it like it is The problem can be just a bad shift solenoid a scanner can test this ( (Factory type) or install a pressure gauge to line port on ...
Question about Chevrolet Malibu
...reverse/neutral from insidr car,if i move bar over from under hood it will go into drive,after that it will for a bit then wont shift again Most likely you need a new shift cable. There are bushings ...
...reverse, it makes a "thunk" under the floorboard near the front of the console. I believ it could be a tranny mount?? Anyone else have any ideas what it could be?? BTW, i drove this car for 2 hours ...
...position. The peg is stopping it. Seems like it should go back up in a clockwise manner where it wont be hitting the peg. When I turn the car off the needle just hangs straight down. Never saw
Question about Chevrolet Malibu
...reverse, but not drive. It attempts to move forward if you hit the gas in drive, but wont move, just kinda leans into it. I opened the pan and it was mostly black fluid, while the filter fluid had a ...
Question about Chevrolet Malibu
reverse way) or gatting stuck not opening. Engine might die it you wont have it checked ASAP. Also if you bought an aftermarket cap (not for GM) it might cause the ptoblem with coolant pressure. Check
...wont come slacken the handbrake adjuster right off if still will not come off the put the wheel back on in reverse and place a plank on the back and wack with a 14lb hammer ,if it still will not move ...
1,923 questions posted
Usually answered in minutes!
1,306 Questions
1,094 Questions
1,067 Questions
997 Questions
1,026 Questions