1994 Mitsubishi Mighty Max "engine" Questions

...very experienced and skilled to replace the crankshaft, and of course you will need to remove the engine first and mount it on a good engine stand before you can even begin the process of replacing ...

engine light and dont run i have a 91 mighty max with fuel injection. the truck runs great until it gets warm and the engine light comes on and the the truck revs up and down and will only tac about ...

how to check engine code hello, i have a 1993 mighty max pick up, it wants to die at idle but fine when you give it gas and the engine light is on. Does any one know how to check it to find the code? ...

I need to know how much fluids do the radiator hold? the engine is over heating. engine is over heating it would be the thermostat needs changing. rads hold around 2.4 liters. depending on the engine ...

engine backfire's when you let off gas but idle's fine 1988 mighty max 4x4 Engines backfire when timing has slipped. You might need a new timing belt. \ Timing belt goes from Crankshaft on bottom of ...

...although I think you should have the 3.0L For the 2.4L: Firing Order: 1-3-4-2 Cylinders: (back of engine) .......4 .......3 .......2 .......1 (front of engine) Distributor: .......(back) ...

...the wrong fluid out im trying to figure out what fluid i let out? The transmission is bolted to the engine and if you drained fluid from a single drain plug, you probably drained the engine oil out, ...

...On Vehicle Inspection If a clanging noise due to the lash adjuster produced immediately after the engine has started or during operation persists, perform the following checks: Check the engine

the truck has no spark, have replaced the ignition coil and the engine control module..still nothing...HELP please Maby replace your distributer? Or distributer cap? Do you still have your old Engine ...

Engine violently overheating. New thermostat, new radiator cap, just did a flush, and has new coolant. What should I check next Thanks for choosing FixYa and welcome to the site. You need to make sure