1991 Mitsubishi Mighty Max "hydralic clutch problems" Questions

...clutch you need to adjust it. if its hydralic then the master cylinder may be not bleeding off properly when cold or slave sticks when cold. you need to measure pedal free play that is how far pedal ...

...HYDRALIC CLUTCH WHICH IS A CLUTCH MASTER CYLINDER WITH SLAVE CYLINDER.IF YOU HAVING CLUTCH PROBLEMS.CLUTCH IS WORN AND SLIPPING OR YOU HAVE LOW FLUID LEVEL IN CLUTCH MASTER CYLINDER.WHICH CAUSES AIR ...

...Hydralic clutch was out hydralic clutch needed repair. tow short distance{17ml.)home in neutral and found it stuck in gearun able to out Hi if the gear is stuck on gear they are two option there. ...

...FLUID LEAKED OUT.CHECK ALL HYDRALIC LINES FOR LEAKS TO BRAKES AND CLUTCH MASTER CYLINDER TO CLUTCH SLAVE CYLINDER.REASON NO PRESSURE AIR WILL ENTER THE HYDRALIC SYSTEM WHEN FLUID LOW AND LEAK

...Clutch systems need to be closed and full to work properly. On some hydralic systems there is an adjustment you can make. If there is one it would be an adjustment on the clutch pedal itself, you can ...

CLUTCH PEDAL DOWN WITH SOME FORCE. PLEASE ADVISE ME AS TO WHAT THE PROBLEM MIGHT BE,& HOW I CAN SOLVE IT. THANK YOU. SELWYN MENTOR If hydralic, it sound like you have air in the hydralic line. You

...with no adjustment to the clutch performed by me. If the clutch is a manual clutch you might be able to adjust the cable. It yours is hydralic (and I think it is) you will have to replace the

Hi! Shifting out of 1st gear is hard and sometimes sticks, have to almost stop to shift into second. I checked the linkage, fluid levels in both the tranny and clutch pedal. I have not checked the ...

...HYDRALIC SYSTEM.IF FLUID WAS LOW CHECK FOR FLUID LEAKS AROUND LINES TO CLUTCH MASTER CYLINDER AND CLUTCH SLAVE CYLINDER.IF FLUID LEVEL ALL GOOD. LOOK FOR A BROKE CLUTCH RELEASE BEARING OR FORK.CHECK ...

...hydralic clutch or manual clutch.if it is a hydralic it might not be the assembly but the slave cylinder but if manual it could be the spring under your dash or the bushing on the assembly are shot ...