...Remove the radiator cap ,open both drains ,let all the coolant run out, if there is no radiator plug remove the lower hose , remove the heater demister hoses, with the heater control on hot flush out ...
...Remove the inlet radiator hose from the radiator. Detach the transmission oil cooler lines from the fan shroud. Disconnect the fan clutch connector. Fan clutch removal and installation Use a J 46406 ...
...remove radiator from2002 trailblazer First drain any coolant in some type of bucket or pan. To do this place the container under the right side of the radiator as you are facing it. Locate the ...
...radiator hose to the engine, it is connected to the thermostat housing. Loosen and remove the two bolts, lift the housing and remove thermostat, make sure the new thermostat goes back in the exact ...
Question about Chevrolet TrailBlazer
...plug 2004 chevy trailblazer 4x4 need to drain a little water out to install antifreeze mix There is no radiator drain plug on these trucks, you have to remove the lower radiator hose to drain
Question about Chevrolet TrailBlazer
...Remove radiator hose from thermostat housing. Remove two bolts from housing and remove from engine. Reinstall is reverse keeping in mind the following: Cleanliness counts where thermostat housing ...
...thermostat is located in the housing where the upper radiator hose connects to the engine. There are 2 14mm bolts that hold the housing down, remove the bolts and housing and replace the
Question about Chevrolet TrailBlazer
...this a hole in the radiator or is it the water pump? Once I let it cool off for 20 minutes I removed the radiator cap . I let it cool off further and filled it back up and drove it 1/4 of a ...
...radiator * Remove the electrical connector from the shroud * Position the water pump so the bolts are aligned in the vertical position **Important note** If you cannot get the special wrench or a ...
radiator so that coolant doesn't run out when you remove the housing. Remove the housing (usually don't need to remove hose) and scrap clean both surfaces of the housing and the block. Take not of the
2,373 questions posted
Usually answered in minutes!
3,219 Questions
2,541 Questions
1,050 Questions
976 Questions
217 Questions