2003 Mitsubishi Lancer "wiggle" Questions

DTC 27: DRIVER-SIDE SEAT BELT PRETENSIONER OPEN CIRCUIT MITSUBISHI LANCER ES 2003 SRS ON wiggle the wires under the seat

All tires are newly replaced by brand new tires, wheel alignment,tire balance and correct cam were done. Problem: The front wheels and car's body are wiggling at accelerated speed. Please help. Dan ...

one of the tires of my car wiggles and i can't seem to find out the reason. how do i repair it? Sounds like one of the wheels could be unbalanced. To fix this you'd need to take it to the dealer or a ...

...it to open,,,door locks are not as good as you may think,,,put the kye into the lock and gently wiggle as you turn and slowly pull the kye out the lock be very gentel with this as you dont wont

...wires gets bent or kinked it is always going to be hard to move. If you are careful and gently (wiggle back and forth) turn the knob you should be able to use it till you can get the cable ...

...IS DRAGGING THE CABLES ARE NEXT. BATTERY CABLES CAN BE TRICKY, THEY MAY LOOK FINE, BUT CAN BE BAD. WIGGLE & PULL ON THE CABLES, THEY COULD BE THE PROBLEM. WHILE CRANKING, CHECK FOR HOT SPOTS AT ...

rack and pinion 2006 lancer how to remove the rack and pinion 1. Jack the car onto stands and remove the front wheels. 2. Remove the drivers seat and the lower dash covers over the pedals. 3. THIS ...

...so something is tripping. I wish to know if there is a known issue for Magnas. We've done the "wiggle test". Would the plugs incur a problem like this? Our local mechanic hooked up an electrical ...

...side out After removing the two screws, you have to grab both sides of the tail light housing and wiggle the housing out by rocking it left and right while GENTLY pulling it away from your body.

...bolts ,then place new clutch in position and finger tighten bolts ,then refit bellhousing with a wiggle and as the clutch is loose it can move and align up .then when i have the bellhousing in ...