2006 Mazda Tribute "back passenger tire moving" Questions

...passenger side middle seat back as far as possible. Obtain your tire tool (the one you would use to remove the lugnuts) Observe the carpeting behind the front passenger seat; you will see a small ...

...back but i thought on rear wheel drive vehicles you were supposed to criss cross any advice Move the passenger side rear tire to the front, and passenger side front to driver side rear. Switch the ...

...passenger)side tire and when it is off the ground put one hand on front of the tire and the other hand on the back of the tire and try to move it back and forth,if it moves a decent amount then look ...

passenger side with increased speed it starts shimmering real bad,just replaced the CV axle Is the front wheel bearing/hub tight ? One question, how is the tire? Have a professional take a look at the

...again. If the vibration moves to the back it's most likely the (now) passenger side rear tire that's out of balance. If the is no change, try the driver's side tires. Hope this

...passenger front tire feels real funny we. Driven. Lugnuts are tight but I can still move the tire back and forth (wobbling it). Just started doing it yesterday. I Checked tire pressure, wear, checked ...

...back the power front passenger seat on my 2002 eddie bauer explorer will not move after being placed all the way forward replace seat switch. Only good for so many actuations, wears out! Think about ...

back end wants to come around. Never notice if both tires are on an icy patch. And is more noticeable if passenger tires are going over ice then if just the driver side is going over an icy patch. I'm

...passenger side whilr driving the right side makes noise It is possible you have a tire that is out of balance or a bent rim. Also if you swap the tires front to back on the right side, see if the ...

passenger side back tire and switch it with the drivers side front tire. then you take the drivers side back tire and switch it with the passenger side front tire. make sure the bolts are tight as you