Bissell 3522 PowerForce Bagged Upright Vacuum "remove plate" Questions

...plate and remove any dirt that may exist in belt area. • Remove beater bar by gripping the belt side of the beater bar and carefully lifting it out. • Remove worn or broken belt. • Clean beater bar ...

...place can be removed. To remove the bottom plate Disconnect cleaner from outlet. Use a Phillips screwdriver to remove the 5 screws on the bottom plate. Lift off bottom plate. Hope this was

...plate. Remove the other black plate like a trapezoid shape on the bottom just by pulling down on the widest part. After removing that you will see four more screws in the clear part hidden deep in ...

...off the bottom plate, but one screw seems to be stripped. How can I remove it? drill the head down to the shaft of the screw then remove plate, remove remainder of screw if possible, fit new

...remove the sole plate: 1. Lie the dyson on it's side so you can access the underside or sit on a chair, turn the vacuum upside down and hold it between your knees. 2. Using a coin or a large ...

...plate is off, remove the slide in tabe from the white plastic protectors and remove them. Slide the tabs of the new cord into the protectors and then push the protectors back on the vacuum tabs. ...

...remove the plate. The back part of the plate usually locks in with tabs. Remove the plate, then pull out the brush. The bearing will come out of slots. Remove the bearings, and more than likely you ...

...look like and how to remove the front bottom plate. 5411 HG Front Bottom Plate Windsor Sensor S12 XP12 SR12 86138280 allstar... ...

...plate. Remove the screws holding the motor and fan assembly to the nozzle housing. Remove the screws Holding the fan housing to the motor to gain access to the fan. Remove the bolt holding the fan on ...

...4 screws on the floor brush and still unable to remove plate. I had the same problem. Remove the rear x2 wheels, there is two more screws below them. Then use gently force to remove the below